12017 - EPL

Case IH 12017 - EPL – Electronic Park Lock (EPL) controller: Power stage supply failure

Issue description

The internal service voltage required to operate the power stage (which drives the electronic park lock actuator motor) is missing, out of range, or failing internally within the module.

Applies to these machines

  • VESTRUM CVX
  • Puma 140
  • Puma 165
  • Puma 180
  • Puma 185
  • Puma 195
  • Puma 210
  • Puma 225
  • Puma 240
  • Magnum 180
  • Magnum 200
  • Magnum 220
  • Magnum 240
  • Magnum 255
  • Magnum 285
  • Steiger
  • Farmall 115U
  • Maxxum

Check the cause

  1. Inspect connectors (X012, X036, X121, X745) and wiring for corrosion, pushed pins, or wire chafing.

  2. Verify the EPL module is receiving proper battery voltage and has a clean ground.

  3. Enter the tractor's diagnostic H-menu (using diagnostic test switch tool 380000843 if necessary) to monitor circuit voltages for sudden drops (menu H9) and perform a switch operation test (menu H5).

Repair steps

  1. Disconnect Battery

    Always disconnect the battery before servicing the EPL system to prevent accidental actuation or short circuits.

  2. Inspect and Test the Relay

    Locate the electronic parking brake relay (X036). Test the relay for proper switching and resistance. Replace the relay if it is sticking or burnt.

  3. Repair Harness

    If testing reveals a short or open circuit in the wiring harness leading to the X745 EPL connector, repair the damaged wires or replace the connector housing/pins.

  4. Replace the EPL Module

    If the wiring, relay, and external power supply are all verified as good, the 12017 code indicates an internal failure of the EPL controller's power stage. The EPL actuator/controller module must be replaced.

  5. Clear Codes

    After repair, enter the diagnostic H-menu. Navigate to menu HC to clear all stored fault codes from the EPL controller.

  6. Calibrate the EPL

    If the EPL module is replaced, you must perform a calibration. Use the H-menu to calibrate the applied and released positions of the park lock (the display will show "M" during the process, and "EPL applied" when finished).

Parts you might need

(5)
  • Electronic Park Lock (EPL) Controller / Actuator

    MANHRN00083

    CNH Industrial Reman part number. Verify exact part number with the dealer using the tractor's PIN/Serial Number.

  • Electronic Park Lock (EPL) Controller / Actuator

    MANHMO00083

    CNH Industrial Reman part number. Verify exact part number with the dealer using the tractor's PIN/Serial Number.

  • Electronic Parking Brake Relay (X036)

    Generic standard CNH micro-relay.

  • EPL Connector Repair Kit

    FCI SICMA 24-way Multipole Connector (Female).

  • Diagnostic test switch

    380000843

    Required to access the H-menu on some models.

Get help to fix this fault by requesting a quote

Browse other Case IH codes