Case IH 14102 – Instrument Cluster (ICU / ADIC): SWCD present - not configured

The Short Wide Color Display (SWCD) monitor is physically connected to the tractor's CAN bus and is broadcasting a signal, but the tractor's main instrument cluster is programmed to believe that no SWCD is installed. It is a software configuration mismatch.

• MAXXUM T4E
• Puma/Mid Range Magnum
• Case IH Puma series
• Case IH Magnum series
• Case IH Steiger series
• Case IH Maxxum series

1. 1

   Verify physical installation of the SWCD monitor in the cab

2. 2

   Determine if the monitor was recently added (needs cluster update) or removed (cluster needs to be told it is gone)

3. 3

   If no monitor changes were made, inspect the CAN bus wiring and SWCD jumper harness for shorts that might be sending erratic ghost presence signals to the cluster

1. 1

   Turn the key start switch to the ON position.

2. 2

   Enter the Configuration/Calibration mode on the instrument cluster display.

3. 3

   Navigate the menu until the display reads CONFIG ICU.

4. 4

   Use the INCR (Increase) or DECR (Decrease) keys to highlight Controller Config and press the PROG (Program) key.

5. 5

   The display will prompt you to choose between MANUAL and AUTO. Select MANUAL and press PROG.

6. 6

   Toggle through the controller menus until the bottom of the display reads SWCD.

7. 7

   Use the INCR or DECR key to change the setting. Select YES if the monitor is installed, or NO if the monitor has been removed.

8. 8

   Press the PROG key to save the configuration.

9. 9

   Exit the configuration menu and cycle the tractor's key switch off and back on to verify the fault code has cleared.