15299 - AST

Case IH 15299 - AST – Steering Valve Controller (SVC): Incorrect steering valve controller configuration - Protocol configuration checksum

Issue description

This code indicates that the Advanced Steering (AST) control subsystem has detected a mismatch, corruption, or error in the protocol configuration data. Specifically, the checksum for the steering valve controller's protocol configuration does not match the expected value, meaning the software parameters are either missing, corrupted, or incorrectly programmed.

Applies to these machines

  • MAXXUM T4E
  • VESTRUM CVX
  • AFS Connect Magnum Tractors (180, 200, 220, 240, 250, 280, 310, 340, 380)
  • Vestrum CVX Series Tractors (100, 110, 120, 130)
  • Farmall Tractors (40, 45, 50, 115U)

Check the cause

  1. Enter the diagnostic mode by navigating the 'H' menus using the switches on the instrument cluster.

  2. Navigate to the R1 module, select menu H3, and select the AST system.

  3. Press the dimming key to accept the menu selection.

  4. Observe the lower LCD section of the display for 'ch - - ' to indicate the configuration channel.

  5. Verify the software versions. A checksum error often means the Steering Valve Controller (SVC) software or the Advanced Steering Configuration dataset is out of date or corrupted.

Repair steps

  1. Reflash and recalibrate software

    Connect the Case IH Electronic Service Tool (EST). Reload the Advanced Steering Configuration controller dataset and the Steering Valve Controller (SVC) software to overwrite the corrupted protocol.

  2. Verify configuration

    Run the steering calibration procedure to ensure the vehicle geometry and internal monitoring configurations are successfully saved without triggering subsequent codes (like 15300, 15301, or 15303).

  3. Replace steering valve controller

    If the controller repeatedly drops its configuration and the checksum error returns immediately after a successful flash, the internal memory of the Steering Valve Controller is likely failing. The physical steering valve controller unit must be replaced, followed by a complete software flash.

Parts you might need

(3)
  • Steering Valve Controller (SVC) Software

    51631896

    Version 2.02

  • Advanced Steering Configuration Controller Dataset

    51573865

    Version 3.2

  • Hydraulic Steering Valve Controller Unit

    The physical controller hardware part number is highly specific to the exact tractor model and hydraulic block configuration. Consult the specific model's parts catalog using the tractor's PIN to order the correct replacement SVC module.

Get help to fix this fault by requesting a quote

Browse other Case IH codes