Case IH 19583 – Engine Control Module (ECM) / Instrument Cluster (ADIC/TECU): Long distance with oil change warning

This is a maintenance and service interval alert indicating that the machine has been operated past its programmed distance or time interval since the last engine oil change reset.

• Tier 4b
• Puma Series
• Maxxum
• Magnum
• Farmall
• JXU series
• STM N Series Loaders

1. 1

   Verify the instrument cluster to confirm the engine hours or distance has exceeded the programmed oil change interval

2. 2

   Inspect the engine oil dipstick to ensure the oil level is safe and check for severe degradation or fuel dilution

3. 3

   Ensure there are no active sensor failures or critical oil condition codes (e.g., 19585 Low oil viscosity, 19593 Oil level sensor fault)

1. 1

   Warm up the engine slightly to help the oil flow, then shut the machine down.

2. 2

   Drain the old engine oil from the oil pan.

3. 3

   Remove the old engine oil filter and clean the filter housing mating surface.

4. 4

   Install a new OEM engine oil filter.

   Lubricate the gasket with fresh oil before tightening.

5. 5

   Refill the engine with the correct capacity and grade of fresh engine oil as specified in your operator's manual.

6. 6

   Reset the service interval monitor in the tractor's instrument cluster display or via the CNH Electronic Service Tool (EST).

   Crucial Step: If the interval is not reset in the ECM, the 19583 fault code will remain active.