Case IH 2071 – Transmission Controller (Trans / TCU): Forward switch input from the FNRP Pod is shorted to ground or is open circuit.

The FNRP (Forward/Neutral/Reverse/Park) Pod is the shuttle lever assembly used by the operator to select the tractor's direction of travel. This code triggers when the controller detects an electrical fault—either a broken connection (open circuit) or a wire touching the chassis/ground (short to ground)—preventing the system from recognizing when the operator shifts into the forward gear. As a result, the tractor will typically fail to move forward or backward.

• Maxxum
• Magnum
• Steiger T4B
• Case IH Magnum Series
• Case IH Steiger / Quadtrac Series
• Case IH Puma Series

1. 1

   Rapidly cycle the FNRP shuttle lever between Forward, Neutral, and Reverse multiple times to free up potentially stuck switch contacts.

2. 2

   Inspect the wiring harness connecting the FNRP pod to the transmission controller for pinched wires, chafing against the steering column, or disconnected plugs.

3. 3

   Use a multimeter to test the forward switch input pins on the FNRP pod connector for continuity to verify if the switch has failed internally.

1. 1

   Power Down

   Turn off the tractor and disconnect the battery to ensure safety while working on electrical components.

2. 2

   Remove the Steering Wheel

   On models where the FNRP pod is column-mounted, remove the center cap and unbolt the steering wheel to gain access to the column assembly.

3. 3

   Remove Column Covers

   Take off the upper and lower steering column covers (or the specific FNRP pod covers) to expose the switch mechanism.

4. 4

   Disconnect Wiring

   Locate and disconnect the electrical wiring harness plugged into the gear selector assembly.

5. 5

   Remove the Faulty Switch

   Unbolt the retaining hardware holding the FNRP shuttle lever/switch assembly in place and remove it from the column.

6. 6

   Install the New Part

   Mount the new FNRP control lever and secure it with the retaining hardware.

7. 7

   Reassemble

   Reconnect the wiring harness, ensuring the connector is fully seated. Reinstall the steering column covers and the steering wheel.

8. 8

   Test

   Reconnect the battery, turn on the tractor, clear the stored fault codes, and test the forward and reverse functions to ensure proper operation.