2343

Case IH 2343 – Transmission (TRANS) controller: Clutch B solenoid - open circuit or short circuit to ground

Issue description

The controller has detected a break in the wiring (open circuit) or a short to ground in the electrical circuit that controls the Clutch B (or Even) hydraulic solenoid.

Applies to these machines

  • Magnum
  • Puma/Mid Range Magnum
  • Steiger T4B
  • Case IH Magnum series
  • Case STX Steiger series
  • Case IH Puma series

Check the cause

  1. Inspect the electrical feed line and wiring harness for the Clutch B solenoid for any visible damage, breaks, or chafing.

  2. Inspect the connector pins at the solenoid and the transmission controller for corrosion, bent pins, or loose connections.

  3. Test the battery voltage and the feed line, as a weak battery or connector can cause low voltage readings.

  4. Use a multimeter to test the resistance of the solenoid coil to determine if the coil itself is internally open or shorted.

Repair steps

  1. Locate solenoid

    Locate the Clutch B solenoid on the transmission control valve block.

  2. Disconnect harness

    Disconnect the electrical harness connector from the solenoid.

  3. Repair wiring

    If the wiring harness is damaged, repair or replace the affected section of the harness.

  4. Remove solenoid

    If the diagnostic tests indicate a damaged solenoid coil, remove the retaining nut/bolt and slide the old solenoid coil off the valve stem, or remove the entire solenoid valve assembly depending on the specific transmission design.

  5. Install new solenoid

    Install the new hydraulic solenoid or solenoid coil.

  6. Reconnect harness

    Reconnect the electrical harness and ensure the connector is fully seated and locked.

  7. Clear codes

    Clear the fault codes from the transmission controller.

  8. Calibrate clutch

    Perform a transmission clutch calibration procedure (often required when replacing transmission clutch components).

  9. Test operation

    Test operate the tractor to verify the code does not return and the transmission shifts correctly.

Parts you might need

(4)
  • Transmission Solenoid Valve

    48055262

    also known as 48055262R and 87729558R - for select Case IH tractors

  • Solenoid assembly

    349295A1

    Powershift solenoid for MX/MTX series

  • Solenoid coil

    84259238

    fits the 349295A1 assembly

  • Master Clutch Solenoid

    84167521

    for Steiger models

Get help to fix this fault by requesting a quote

Browse other Case IH codes