Case IH 2388-00 - BCM – BCM: Work lamp #8 - too many loads or faulty load
Issue description
The module monitoring the lighting circuit has detected an excessive current draw on the specific output pin assigned to Work Lamp #8. This typically means there is a short circuit to ground, a failed bulb/LED assembly drawing too much amperage, or too many aftermarket accessories spliced into that specific lighting circuit.
Applies to these machines
15 machines- MAGNUM AFS Connect
- Axial-Flow Combines 2377
- Axial-Flow Combines 2388
- Axial-Flow Combines 2577
- Axial-Flow Combines 2588
- Axial-Flow Combines 5088
- Axial-Flow Combines 5130
- Axial-Flow Combines 5140
- Magnum Tractors 180 through 380 series
- CX100
- MX100
- MX135
- CPX420
- CPX610
- Module Express 625
Check the cause
Check Work Lamp #8 circuit for a short to ground
Inspect the Work Lamp #8 bulb or LED assembly for internal failure causing excessive amperage draw
Verify if any aftermarket accessories have been spliced into the Work Lamp #8 circuit, causing an overload
Parts you might need
(5)Work Lamp (Right-Hand)
138224A1Fitment includes Case IH Axial-Flow Combines (e.g., 2388).
Work Lamp
417788A1Fitment includes Case IH Axial-Flow Combines.
Work Lamp
178345A1Fitment includes Case CX/MX series tractors and Magnum series tractors.
OEM LED Work Lamp Kit
51537796Fitment includes various Case Construction and Agricultural equipment.
LED Work Lamp, Flood/Spot Combo, Rectangle
WL1300Aftermarket Alternative (A&I Products) - Fits Case IH combines and cotton pickers.
Get help to fix this fault by requesting a quote
