2555

Case IH 2555 – UCM: Transmission oil pressure below warning pressure

Issue description

The transmission fluid pressure has dropped below the safe operating threshold. Proper oil pressure is critical to keep gears, clutches, and hydraulic circuits working smoothly; a drop in pressure can lead to rough shifting, overheating, or severe transmission damage.

Applies to these machines

  • Optum
  • Case IH Puma Series
  • Case IH Maxxum Series
  • Case IH Magnum Series

Check the cause

  1. Verify the transmission fluid level and condition, as low oil is a primary cause of pressure problems.

  2. Check the wiring harness connected to the transmission oil pressure sensor/switch for moisture, dirt, or damaged wires that could cause erratic readings.

  3. Clear the error code from the UCM and test the system for normal operation to see if the code returns.

  4. If the code persists and the sensor is ruled out, inspect the hydraulic circuit for internal leaks or pump issues.

Repair steps

  1. Park and cool down

    Park the tractor on a level surface, turn off the engine, and allow the transmission to cool.

  2. Locate sensor

    Locate the transmission oil pressure sensor. Depending on the model, it is typically located on top of the transmission case or accessible by removing a small access panel.

  3. Disconnect wiring

    Disconnect the electrical wiring harness from the sensor.

  4. Remove old sensor

    Unscrew and remove the old sensor from the transmission housing.

  5. Install new sensor

    Apply a dab of thread sealant to the threads of the new sensor (if it does not come pre-applied) and thread it directly into the port.

  6. Reconnect wiring

    Reconnect the electrical wiring harness, ensuring the connection is sealed against moisture.

  7. Check fluid level

    Check the transmission fluid level and top off any fluid that may have been lost during the swap.

  8. Clear code and test

    Turn the key switch ON, clear the fault code, and test the tractor to ensure the warning light remains off and the display shows accurate pressure readings.

Parts you might need

(7)
  • Transmission Oil Pressure Sensor / Switch

    121767A1

    Common for Case IH Maxxum and older Puma/Magnum models

  • Transmission Oil Pressure Sensor / Switch

    1964832C1

    Superseded/alternate Case IH number

  • Transmission Oil Pressure Sensor / Switch

    1983225C1

    Superseded/alternate Case IH number

  • Transmission Oil Pressure Sensor / Switch

    1983225C2

    Superseded/alternate Case IH number

  • Transmission Oil Pressure Sensor / Switch

    47977004

    Common for newer Case IH Puma and New Holland T7 series

  • Transmission Oil Pressure Sensor / Switch

    87494633

    Common for newer Case IH Puma and New Holland T7 series

  • Transmission Oil Pressure Sensor / Switch

    87564684

    Common for newer Case IH Puma and New Holland T7 series

Get help to fix this fault by requesting a quote

Browse other Case IH codes