3753 (F-1116-31) - ECU

Case IH 3753 (F-1116-31) - ECU – Engine Control Unit (ECU) / Electronic Diesel Control (EDC): ECU internal failure - Injection quantity correction

Issue description

This code indicates an internal failure within the engine controller regarding the self-learning parameters for fuel injection quantity correction. The ECU is unable to properly calculate or apply the correction factors required for the fuel injectors, triggering a Level 2 Monitoring fault. If full power loss is experienced, emergency re-starts (allowing 30 seconds of operation without power loss) are only enabled after the engine has been commanded to low idle.

Applies to these machines

  • VESTRUM CVX
  • Case IH 240 Series Axial-Flow Combines (7240, 8240, 9240)
  • Case IH Steiger series tractors
  • Case IH Magnum series tractors
  • Case IH Puma series tractors

Check the cause

  1. Connect the CNH Electronic Service Tool (EST) to the machine's diagnostic port.

  2. Check for any active or logged codes related to fuel pressure, injector circuits, or sensor supply voltages (such as 12V sensor supply faults) that could be causing secondary ECU calculation errors.

  3. Verify if the fault is active (Amber warning). The primary diagnostic step mandated by the OEM for this specific internal failure is to attempt to restore the self-learning parameters via the service tool before condemning the hardware.

Repair steps

  1. Restore Parameters

    Using the CNH EST, follow the appropriate service tool procedure to restore the engine's self-learning parameters.

  2. Reload Dataset

    If restoring the parameters does not clear the fault, use the service tool to reload the engine dataset (re-flash the ECU software).

  3. Replace Controller

    If the fault persists after reloading the engine dataset, the Engine Controller (ECU/EDC) has suffered a permanent internal hardware failure and must be replaced.

  4. Post-Replacement Calibration

    If the EDC is replaced, you MUST follow the appropriate service tool procedure to restore the self-learning parameters and calibrate the new controller to the engine.

Parts you might need

(8)
  • Engine Control Unit (ECU) / Electronic Diesel Control (EDC) Module

    0281020057

    Bosch Part Number (0281-020-057); Fitment: Case IH Puma Series (140, 155, 170, 185, 205, 225, 230)

  • Remanufactured ECU

    48117683R

    CNH OEM Part Number; Fitment: Case IH Steiger / STX Series (STX375, STX500)

  • Remanufactured ECU

    48117682R

    CNH OEM Part Number; Fitment: Case IH Steiger / STX Series (STX375, STX500)

  • Engine Control Unit (ECU) / Electronic Diesel Control (EDC) Module

    84297803R

    CNH OEM Part Number; Fitment: Case IH Magnum, Steiger, Quadtrac

  • Engine Control Unit (ECU) / Electronic Diesel Control (EDC) Module

    84602481

    CNH OEM Part Number; Fitment: Case IH Magnum, Steiger, Quadtrac

  • Engine Control Unit (ECU) / Electronic Diesel Control (EDC) Module

    47398312

    CNH OEM Part Number; Fitment: Case IH Magnum, Steiger, Quadtrac

  • Engine Control Unit (ECU) / Electronic Diesel Control (EDC) Module

    P3681405-RX

    Cummins / CNH Part Number; Fitment: Case IH equipment utilizing Cummins-based engines

  • Engine Control Unit (ECU) / Electronic Diesel Control (EDC) Module

    P4921776

    Cummins / CNH Part Number; Fitment: Case IH equipment utilizing Cummins-based engines

Get help to fix this fault by requesting a quote

Browse other Case IH codes