Case IH 4318 – EHR (Electronic Hitch/Hydraulic Remote): Rear remote no. 7 - not commanded neutral on power-up

This condition occurs when the system powers up and the controller detects that the spool valve for rear remote #7 is not in its neutral position, or the neutral set point has not been commanded/calibrated correctly.

• Magnum
• Steiger T4B
• Case IH Magnum 235 - 340 (Series 4)
• Case IH Steiger series

1. 1

   Connect the Electronic Service Tool (EST) or use the tractor's diagnostic display to check for any other active EHR codes.

2. 2

   Make a note of any error codes, clear them from the system, and cycle the key/power to test the system for normal operation.

3. 3

   If the fault code does not return, the system operation is normal. If the fault is still present, proceed to the repair procedure.

1. 1

   Software/Configuration Check

   Ensure the EHR controller has the correct level of software downloaded. Attempt to re-configure and calibrate the EHR valve using the Electronic Service Tool.

2. 2

   Valve Replacement

   If the valve fails calibration or the fault immediately reoccurs on power-up, the internal sensors/solenoids of the valve have failed.

3. 3

   Remove the faulty EHR valve section

   Locate rear remote valve #7 on the rear hydraulic stack. Safely relieve hydraulic pressure and remove the valve section.

4. 4

   Install the new valve

   Bolt the new EHR valve section into the hydraulic stack and reconnect the electrical harness.

5. 5

   Configure the new valve

   You must use the dealer Electronic Service Tool to download the correct software configuration to the new EHR valve section and calibrate its neutral set point.