Case IH 4324 – EHR (Electronic Hitch/Hydraulic Remote): Rear remote no. 7 - manually operated

The system has detected the spool valve for rear remote #7 is being operated manually (or is registering a manual override condition) rather than responding to electronic commands. Primary failure modes are incorrect hydraulic pressure or a faulty EHR valve.

• Magnum
• Steiger T4B
• Case IH Magnum 235 - 340 (Series 4)
• Case IH STX Steiger tractors (350 - 600 horsepower)

1. 1

   Check for other active EHR error codes, make a note of them, clear them, and test the hydraulic system for normal operation

2. 2

   Verify the hydraulic pressures of the system (refer to the hydraulic testing section in the specific machine's service manual)

1. 1

   Address Pressure Issues

   If the hydraulic pressures tested in the diagnostic phase are incorrect, repair or replace the affected hydraulic supply components (e.g., pump, lines, or pressure relief valves) as required.

2. 2

   Software Configuration

   If the hydraulic pressures are within specification, connect the Case IH Electronic Service Tool (EST). Download the correct level of software and reconfigure the EHR valve.

3. 3

   Valve Replacement

   If the fault re-occurs after the software update and reconfiguration, the EHR valve itself has failed internally. You must remove the EHR valve section for remote #7, replace it with a new unit, and configure the new valve section using the EST.