Case IH 4332 – EHR / ATC: Rear remote no. 8 - not commanded neutral on power-up

When the tractor was powered on, the system detected that the spool for the 8th rear remote valve was not resting in its commanded neutral position.

• Magnum
• Steiger T4B
• Case IH Magnum series (235 - 340 Series 4)
• Case IH Steiger series

1. 1

   Check the system for any other active EHR error codes

2. 2

   If other codes are present, make a note of them

3. 3

   Clear the error code(s) from the system

4. 4

   Cycle the power and test the rear remote system for normal operation to see if the code was a momentary glitch

1. 1

   Ensure the tractor is powered down and hydraulic pressure is relieved.

2. 2

   Locate the rear remote valve stack at the rear of the tractor.

3. 3

   Remove the faulty EHR valve section specifically for Rear Remote No. 8.

4. 4

   Replace the faulty section with a new EHR valve section.

5. 5

   Connect the electronic service tool to the tractor, download the correct level of software, and configure the new EHR valve section to the tractor's network.