4517

Case IH 4517 – Primary Hydraulic Power System / Front Electronic Hydraulic Remote Valves (EHR) / Mid-mount remote control valve: Front remote no. 2 – switched to failsafe

Issue description

The Electronic Hydraulic Remote (EHR) valve for the front/mid-mount remote #2 has detected an internal or external anomaly. To prevent unintended hydraulic movement or damage, the system has disabled the valve and forced it into a "failsafe" mode.

Applies to these machines

  • Puma/Mid Range Magnum
  • MAXXUM T4E
  • VESTRUM CVX
  • Case IH Puma series
  • Case IH Magnum series
  • Case IH Steiger series
  • Case IH Maxxum & Optum series
  • Case IH Farmall (Pro / EP models)

Check the cause

  1. Check for primary codes using the Electronic Service Tool (EST) or onboard HH diagnostic menu (look for accompanying codes 4518–4527).

  2. Clear all error codes from the system and retest the remote valve for normal operation.

  3. Inspect the wiring harness and connector at the front remote valve #2 for damaged wires, pushed-out pins, or corrosion if voltage or driver fault codes return alongside 4517.

Repair steps

  1. Address Accompanying Codes

    If other codes returned after clearing, diagnose and repair those specific circuits first (e.g., replacing a faulty in-cab remote switch/potentiometer if code 4525 is present).

  2. Software Flash

    If only error code 4517 is still displayed, the issue may be software corruption. Use the CNH EST to download the correct level of software to the EHR valve and reconfigure it.

  3. Replace the Valve Section

    If the fault re-occurs after a software flash and reconfiguration, the internal sensors or pilot head of the EHR valve section have failed.

  4. Removal

    Relieve all hydraulic pressure. Disconnect the electrical harness from Front Remote No. 2. Unbolt the faulty EHR valve slice from the hydraulic stack.

  5. Installation

    Install the replacement EHR valve section and torque the tie-bolts to spec.

  6. Calibration

    You must use the EST or the tractor's HH menu to configure and calibrate the new EHR valve section before it will operate.

Parts you might need

(3)
  • Electronic Hydraulic Remote (EHR) Valve Section / Mid-Mount Valve Slice

    87330318R

    Example OEM Part Number (Magnum Series) - Remanufactured 5-stack remote hydraulic valve

  • Electronic Hydraulic Remote (EHR) Valve Section / Mid-Mount Valve Slice

    51443156R

    Example OEM Part Number (Magnum Series) - Remanufactured 5-stack remote hydraulic valve

  • In-Cab Potentiometer/Switch

    87605245

    If applicable to a 4525 code. Replaces older numbers 82021037, 87559698, etc.

Get help to fix this fault by requesting a quote

Browse other Case IH codes