51053

Case IH 51053 – REMOTE (AUX) CONTROLLER / TMF: Aux 1st Lower Coil solenoid shorted to 12 volts

Issue description

The circuit responsible for controlling the lowering function of the first auxiliary remote hydraulic valve is receiving unintended 12-volt power. This is typically caused by a wiring harness shorting to a power source or an internal short circuit within the solenoid coil itself.

Applies to these machines

  • MX Magnum
  • STX Steiger
  • MX Magnum Series
  • TG Series
  • Steiger Series
  • Puma Series
  • Magnum Series

Check the cause

  1. Inspect the wiring harness leading to the 1st auxiliary remote valve for chafing, melting, or pinched wires that could cause a short to a 12-volt power source

  2. Disconnect the 1st lower coil solenoid and test it with a multimeter for an internal short

  3. Verify that the internal controller relay has not failed, as this can force the hitch/aux valves to short to 12 volts

  4. Check tractor hitch and remote calibrations to ensure no data loss or aborted calibrations are contributing to controller errors

Repair steps

  1. Power Down

    Turn off the tractor and disconnect the battery to prevent electrical spikes while servicing the controller circuits.

  2. Locate the Valve

    Locate the 1st auxiliary remote valve block, typically situated at the rear of the tractor. Identify the specific solenoid responsible for the 'Lower' function.

  3. Address Wiring Issues

    If the diagnostic checks revealed a short in the wiring harness, repair or splice the damaged wires and secure them in a protective loom away from pinch points.

  4. Replace the Solenoid

    If the wiring is intact but the solenoid tested as internally shorted, remove the retaining nut/hardware holding the defective 1st lower coil solenoid and slide it off the proportional valve stem.

  5. Install New Part

    Slide the replacement remote valve solenoid onto the valve stem and secure it.

  6. Reconnect and Clear Codes

    Reconnect the wiring harness and battery. Use the tractor's diagnostic interface to clear the error codes from the Multifunction Controller.

Parts you might need

(4)
  • Remote Valve Solenoid

    278506A1

    Replaces/Interchanges with 87778144, 87354468, and 278506A2

  • Remote Valve Solenoid

    87778144
  • Remote Valve Solenoid

    87354468
  • Remote Valve Solenoid

    278506A2

Get help to fix this fault by requesting a quote

Browse other Case IH codes