Case IH 520445-00 - BCM – Engine ECU, Transmission TCU, IBC Controller: Throttle Valve Actuator Error / DANA Transmission Configuration Error / DEF Pump Motor Communication / Intelligent Boom Control

The specific fault code 520445-00 associated with the BCM could not be found. Fault code 520445 is assigned to several different technical conditions: Throttle Valve Actuator Error (partial short circuit), DANA Transmission Configuration Error (internal module reverts to shutdown mode), DEF Pump Motor Communication (erratic/incorrect data), and Intelligent Boom Control (missing jib boom cylinder sensor CAN controller).

• MAGNUM AFS Connect
• Case IH and New Holland equipment utilizing DANA transmissions, Deutz Euro 5 emissions systems (DEF), or intelligent boom lift systems

1. 1

   For the Throttle Valve: Check the wiring harness for a partial short circuit.

2. 2

   For the Throttle Valve: Check the load and output of the actuator.

3. 3

   For the Transmission: Turn the power off and restart the vehicle.

4. 4

   For the Transmission: If the error occurs right after a firmware update, check if the data flash is corrupt.

5. 5

   For the Boom Sensor: Check the sensor connections for a possible wire break.

1. 1

   Repair wiring harness

   Throttle Valve: If the failure is present after checking the load and output, repair the wiring harness.

2. 2

   Replace Throttle Valve / Actuator

   Throttle Valve: If the short circuit is internal, replace the Throttle Valve / Actuator.

3. 3

   Perform controlled power-down

   Transmission: Perform a controlled power-down.

4. 4

   Contact maintenance / Spicer Off-Highway

   Transmission: If the code persists, contact maintenance/Spicer Off-Highway to re-flash or replace the internal module.

5. 5

   Repair wire break

   Boom Sensor: Repair the wire break to restore CAN controller communication so intelligent boom functionality can be used.