523275 - 03 - CSM

Case IH 523275 - 03 - CSM – CSM: Cab suspension right position - cab suspension right position high

Issue description

Indicates an issue with the right-hand position sensor of the cab's active suspension system. The sensor is sending a signal to the controller that is higher than the expected operating range, which could be caused by a short to power, an open ground circuit, a faulty sensor, or the suspension physically overextending.

Applies to these machines

  • MAGNUM AFS Connect
  • AFS Connect Magnum Tractors (Tier 4B) 180
  • AFS Connect Magnum Tractors (Tier 4B) 200
  • AFS Connect Magnum Tractors (Tier 4B) 220
  • AFS Connect Magnum Tractors (Tier 4B) 240
  • AFS Connect Magnum Tractors (Tier 4B) 250
  • AFS Connect Magnum Tractors (Tier 4B) 280
  • AFS Connect Magnum Tractors (Tier 4B) 310
  • AFS Connect Magnum Tractors (Tier 4B) 340
  • AFS Connect Magnum Tractors (Tier 4B) 380
  • Steiger series

Check the cause

  1. Inspect the right-hand cab suspension shock absorber/actuator and the physical position sensor linkage for damage, disconnection, or physical overextension

  2. Inspect the wiring harness leading to the right cab suspension position sensor for chafing, pinched wires, or corrosion at the connector

  3. Test the sensor circuit for a short to power or an open ground, which typically causes a 'high' voltage reading

Repair steps

  1. Disconnect power

    Disconnect the battery or power to the CSM before servicing electrical components.

  2. Repair wiring harness

    If the wiring harness is damaged, repair the broken/shorted wires and replace the connector if necessary.

  3. Replace sensor

    If the sensor is internally shorted, remove the mounting hardware for the right-hand cab suspension position sensor and install a new sensor.

  4. Restore power

    Reconnect the harness and restore power.

  5. Calibrate sensor

    After replacing a suspension position sensor, the Cab Suspension Module (CSM) will likely require a software calibration routine via the tractor's display or a dealer diagnostic tool to relearn the minimum and maximum travel limits.

Parts you might need

(3)
  • Cab Suspension Position Sensor

    704143A1

    Similar CNH/McCormick part

  • Cab Suspension Position Sensor

    424A16B090

    Similar CNH/McCormick part

  • Rubber Bumper

    523275

    If the physical bump stop is missing or damaged, it could allow the cab to overextend

Get help to fix this fault by requesting a quote

Browse other Case IH codes