Case IH 9317 – Hitch Controller: The Hitch Controller Calibration procedure must be performed

The hitch controller lacks valid calibration data for the hitch's hydraulic valves and position sensors, and must be recalibrated to function properly.

• MX Magnum
• STX Steiger
• TG210
• TG230
• TG255
• TG285
• STX 280-530
• Steiger 280-535
• Puma 125

1. 1

   Ensure the engine is running and the engine speed signal is functioning (must be set above 1600 RPM during calibration)

2. 2

   Ensure the tractor is parked and completely stationary to prevent the controller from aborting the calibration

3. 3

   Verify that the armrest configuration matches the hitch configuration to avoid mismatch codes

4. 4

   Check for Code 10030 (Controller Memory Error - Loss of hitch calibration data) which indicates internal memory failure

1. 1

   Park the tractor

   Park the tractor on a level surface, ensure it is completely stationary, and apply the parking brake.

2. 2

   Start the engine

   Start the engine.

3. 3

   Increase throttle

   Increase the throttle so that the engine speed is maintained above 1600 RPM.

4. 4

   Access calibration menu

   Access the Hitch Calibration menu via the tractor's armrest display or instrument cluster.

5. 5

   Initiate calibration

   Initiate the calibration sequence. The controller will automatically cycle the hitch raise and lower valves.

6. 6

   Complete procedure

   Allow the procedure to finish without moving the tractor or dropping the engine RPM.

7. 7

   Save and verify

   Save the calibration. Cycle the key to verify that code 9317 has cleared and no configuration mismatch codes (like 9319) have appeared.