Case IH A-G-066 - Display – Autoguidance subsystem / AFS Pro 1200 Display: Steering Profile Invalid

This fault code indicates a configuration mismatch within the machine's autoguidance system. It means that the steering valve has reported an unsupported steering axle type to the display.

• MAGNUM AFS Connect
• STEIGER AFS Connect
• Case IH agricultural equipment (tractors, combines, etc.) equipped with the AFS Pro 1200 display and the AFS AccuGuide integrated hydraulic steering system

1. 1

   Verify the vehicle model profile currently selected in the AFS Pro 1200 display

2. 2

   Check the Autoguidance setup menus to see what steering axle type is currently configured

3. 3

   Ensure that the machine's software has not been recently updated or flashed with an incorrect vehicle profile

1. 1

   Acknowledge the Alarm

   Note the fault code on the AFS Pro 1200 display.

2. 2

   Check Valve Configuration

   Navigate to the Autoguidance configuration settings in the display to verify the steering axle type.

3. 3

   Dealer Intervention

   Contact your CASE IH dealer to check the valve configuration. A dealer technician will need to connect the Case IH Electronic Service Tool (EST) to read the steering valve's reported axle type and reconfigure or re-flash the steering controller software so that it matches the physical vehicle profile.

4. 4

   Cycle Power

   After the dealer corrects the valve configuration, cycle the machine's key power to clear the code and initialize the AccuGuide system.