Case IH A-GNSS-110 - Display – Display: Remain Stationary to Initialize GNSS

This code is not a hardware failure. It is an operational prompt indicating that the Global Navigation Satellite System (GNSS) receiver is currently in its stationary initialization phase during power-up. The system requires the tractor to remain completely still to establish its initial satellite lock and orientation.

• MAGNUM AFS Connect
• STEIGER AFS Connect
• Quadtrac AFS Connect

1. 1

   Verify Operator Procedure: Confirm whether the operator is putting the tractor in gear and moving immediately after key-on/engine start.

2. 2

   Check Environment: Ensure the tractor is parked in an area with a clear, unobstructed view of the sky to prevent the system from hanging on initialization.

3. 3

   Monitor Power-Up: Turn the key on and monitor the AFS Pro 1200 display to ensure the initialization naturally completes by the time the display is fully booted up.

1. 1

   Start the tractor's engine.

   Start the tractor's engine.

2. 2

   Do not move the vehicle while the AFS Pro 1200 display and GNSS system are powering on.

   Do not move the vehicle while the AFS Pro 1200 display and GNSS system are powering on.

3. 3

   Allow the system to perform the stationary phase of initialization.

   Allow the system to perform the stationary phase of initialization.

4. 4

   Wait until the display is fully powered on and the A-GNSS-110 prompt clears from the screen.

   Wait until the display is fully powered on and the A-GNSS-110 prompt clears from the screen.

5. 5

   Once the prompt clears and satellite lock is confirmed, the vehicle can be driven.

   Once the prompt clears and satellite lock is confirmed, the vehicle can be driven.