EHR4159

Case IH EHR4159 – EHR: Rear Remote No.5 Neutral Set Point

Issue description

The control system has detected that the number five rear electro-hydraulic remote (EHR) valve's neutral (resting) position is outside of its expected, calibrated parameters. This prevents the proper operation of the hydraulic circuit controlled by this remote.

Applies to these machines

  • Magnum 225
  • Magnum 235
  • Magnum 250
  • Magnum 260
  • Magnum 275
  • Magnum 315
  • Magnum 340
  • Puma Series
  • Maxxum Series

Check the cause

  1. Verify if the fault code is active or stored using the tractor's diagnostic menu on the AFS Pro display

  2. Thoroughly inspect the wiring harness and connectors leading to the number five remote valve for damage, corrosion, moisture intrusion, or loose connections (especially at articulation points)

  3. Check for other active EHR or hydraulic system fault codes (such as under-voltage or over-voltage) that could point to an electrical issue

  4. Swap electrical connectors with an adjacent remote valve (e.g., remote #4) to isolate the fault. If the code moves to the other remote, the pilot head/solenoid is likely faulty. If it remains on remote #5, suspect the control lever or main harness

Repair steps

  1. Repair wiring and connectors

    If any wiring or connector issues were found during inspection, repair or replace the damaged components and ensure all connections are clean and secure.

  2. Calibrate remote valves

    Perform a calibration of the auxiliary remote levers via the diagnostic or settings menu. Follow on-screen prompts to move each remote lever to its full extend and retract positions to re-learn the neutral set point.

  3. Update hydraulic controller software

    If calibration does not resolve the issue, have a Case IH dealer perform a software update on the hydraulic controller, as software bugs are known to cause this fault.

  4. Replace faulty components

    If the issue persists, replace the faulty component identified during diagnostics: the lever potentiometer (if isolated to the armrest), the remote valve pilot head/solenoid, or the entire hydraulic remote valve section for severe internal failures.

Parts you might need

(8)
  • Kit for adding a 5th remote, includes the complete valve assembly

  • Valve Slice/Section

    47735819

    Replaces 59999902

  • Valve Slice/Section (Remanufactured)

    47735819R
  • Remote Valve Sensor/Pilot Head

    Often replaced as a unit; consult dealer for specific part number

  • General Hydraulic System Sensor (Remanufactured)

    47457712R

    Fits various Magnum models. Verify fitment as this may not be the specific position sensor for the remote valve spool

  • General Hydraulic System Sensor

    51408080

    Verify fitment as this may not be the specific position sensor for the remote valve spool

  • O-Ring (20.29mm ID x 2.62mm Thk)

    87635382

    For valve assembly

  • O-Ring (9.19mm ID x 2.62mm Thk)

    87635379

    For valve assembly

Get help to fix this fault by requesting a quote

Browse other Case IH codes