EHR4162

Case IH EHR4162 – ARU: Rear Remote No. 5 Spool Deflection Too Short

Issue description

The electronic control system has detected insufficient movement of the spool within the hydraulic valve for the number 5 rear remote. When the Armrest Control Unit (ARU) commands the spool to move, the position sensor in the pilot head reports that the spool has not traveled the expected distance. This condition prevents the proper operation of the hydraulic function connected to that remote.

Applies to these machines

  • Magnum 235
  • Magnum 315
  • Magnum 340
  • Puma 130
  • Puma 140
  • Puma 160
  • Steiger
  • Quadtrac

Check the cause

  1. Verify if the fault is active by clearing the code and operating the remote valve to see if it returns immediately (intermittent issue check)

  2. Check regulated hydraulic pressure to ensure it is within specification, as incorrect pressure can prevent correct spool movement

  3. Verify that all remote valve pilot heads are running the latest, matching software versions

  4. Calibrate the armrest control levers (paddles) through the tractor's display

  5. Perform the remote valve calibration using a diagnostic tool or pressure sensor

  6. Inspect the wiring harness and connectors leading to the number 5 remote valve for damage, corrosion, or loose connections

  7. Remove the pilot head and manually press the end of the spool to ensure it moves freely within its bore and returns smoothly

  8. Swap the pilot head from remote number 5 with a known working remote (e.g., remote 4) to isolate whether the fault is in the electronic pilot head or the mechanical valve body

Repair steps

  1. Perform diagnostic checks

    Perform all diagnostic checks. The most common solutions are often related to calibration or software. Do not proceed with part replacement unless diagnostics confirm a hardware failure.

  2. Replace pilot head

    If diagnostics point to a faulty pilot head, it must be replaced as a complete assembly. Disconnect the electrical connector, unbolt the pilot head from the valve body, and install the new unit.

  3. Repair or replace valve body

    If diagnostics indicate a problem with the valve body (e.g., a sticking spool), the valve section will need to be removed from the hydraulic stack for disassembly, inspection, and repair or replacement. This process involves removing the tie-rods that hold the valve stack together.

  4. Re-number and calibrate

    After replacing any hardware, re-number the remote valves if necessary, and perform both the armrest lever and remote valve calibration procedures.

  5. Clear codes and test

    Clear all fault codes and test the system thoroughly to confirm the repair.

Parts you might need

(6)
  • Dealer-installed accessory kit including valve and mounting hardware

  • Pilot Head

    Not available separately; serviced as a complete valve assembly

  • Remote Valve Section / Slice

    47735819

    Replaces 59999902. Verify fitment with serial number.

  • Remote Valve Section / Slice (Remanufactured)

    47735819R

    Verify fitment with serial number.

  • O-Ring (20.29mm ID x 2.62mm Thk)

    87635382

    For valve assembly

  • O-Ring (9.19mm ID x 2.62mm Thk)

    87635379

    For valve assembly

Get help to fix this fault by requesting a quote

Browse other Case IH codes