EHR4198

Case IH EHR4198 – Armrest: EHR 5 Offline Error

Issue description

The tractor's control system has lost communication with, or cannot verify the operational status of, the fifth electro-hydraulic remote (EHR) valve. When this valve goes offline, it becomes unresponsive to operator commands, resulting in the complete loss of hydraulic functions for that specific remote and potentially affecting other hydraulic operations.

Applies to these machines

  • Magnum
  • Steiger
  • Puma

Check the cause

  1. Inspect the wiring harness and connectors leading to the fifth EHR valve for wear, abrasion, damage, or corrosion, particularly in areas where the harness may rub against the chassis or other components. Ensure all connectors are clean and securely fastened.

  2. Check with a Case IH dealer for any available software updates that might resolve EHR-related faults.

  3. Swap the electrical connector from the fifth valve with an adjacent, functioning valve to determine if the fault follows the valve (indicating internal solenoid/electronics failure) or stays with the fifth remote (indicating wiring or control module issues).

  4. Inspect the valve and its connections for any hydraulic fluid leaks that could indicate a severe mechanical issue.

Repair steps

  1. Repair or replace wiring

    If damage is found in the wiring harness, repair or replace it. When replacing a lever, note the pin locations to ensure correct installation.

  2. Calibrate remote valves

    Perform calibration through the tractor's A-post display (turn key on while pressing program button, navigate to 'ARM' or 'AUX CAL', and follow on-screen prompts to move remote levers through full range). Some models may require the CAS 2806 calibration tool.

  3. Replace solenoid

    If the valve swap test indicated a faulty valve component, replace the solenoid on the fifth EHR valve. This can often be done without replacing the entire valve assembly.

  4. Replace EHR valve assembly

    If wiring is sound, calibration is complete, and solenoid replacement does not resolve the issue, replace the entire fifth EHR valve assembly.

Parts you might need

(11)
  • 5th Remote Valve Assembly

    51465150

    Verify fitment by serial number

  • Verify fitment by serial number

  • EHR Control Valve Wiring Harness

    84151662

    For 4-spool on Steiger models

  • Fits various older models

  • Remanufactured Hydraulic Valve

    87384974R

    Fits various MX Magnum models

  • Fits various Magnum, MX, Puma, T7, and T8000 series

  • Fits various Magnum and Puma models

  • Fits various 7200 and 9300 series

  • Verify fitment by serial number

  • Solenoid Valve

    KHR11810

    Verify fitment by serial number

  • Verify fitment by serial number

Get help to fix this fault by requesting a quote

Browse other Case IH codes