EHR4318

Case IH EHR4318 – EHR: Rear Remote No.7 Neutral Set Point

Issue description

The Electronic Hitch Remote (EHR) controller is not recognizing that the hydraulic control lever for the number 7 rear remote valve is in the neutral position. This neutral set point failure affects the proper operation of the rear remote and is typically caused by a loss of calibration or a faulty potentiometer within the armrest control lever.

Applies to these machines

  • Magnum 235
  • Magnum 250
  • Magnum 260
  • Magnum 280
  • Magnum 290
  • Magnum 310
  • Magnum 340
  • Magnum 370
  • Magnum 380
  • Steiger 350
  • Steiger 400

Check the cause

  1. Verify that EHR4318 is an active or stored fault code in the tractor's diagnostic system

  2. Inspect the wiring harness between the armrest controller and the rear remote valve for damage, corrosion, or loose connections (pay close attention to the harness at the tractor's articulation point for chafing)

  3. Check for any other active fault codes related to the armrest controller (ARM) or other EHRs, which could indicate a broader system issue

Repair steps

  1. Recalibrate rear remote valves

    Turn the key to the 'ON' position while pressing and holding the program button to enter the configuration menu. Scroll to the 'ARM' or 'Armrest' section, select 'AUX Lever' calibration, and follow the display prompts to move all levers to full extend (rearward) and confirm, then full retract (forward) and confirm. Turn the key off, wait 30 seconds, and restart to see if the fault clears.

  2. Access and test the potentiometer

    If calibration fails, disconnect machine power and access the potentiometer for the #7 remote lever in the armrest by removing the plastic handle and trim. Disconnect its wiring and use a multimeter set to resistance (Ω) to measure total resistance across the two outer terminals (reading should be stable).

  3. Test potentiometer wiper function

    Keep one multimeter probe on an outer terminal and move the other to the center terminal (wiper). Slowly move the control lever through its full range of motion. The resistance reading should change smoothly without sudden jumps or dropouts. If erratic, the potentiometer is faulty.

  4. Replace faulty components

    Replace the faulty potentiometer or the entire remote valve assembly if necessary, ensuring the replacement part matches the specific tractor model and serial number.

Parts you might need

(5)
  • Replaces multiple part numbers including 82007044, 82011878, 82017877, 82018521, 82021035, 82021037, 87543715, 87559698, 87559705, and 87605246.

  • Fits various Magnum models including 7200 and 8900 series.

  • Case IH OEM part.

  • Fits early Magnum 7100 series tractors.

  • Remote Valve - Right Hand

    47595558

    Entire remote valve assembly for various Magnum and Steiger models. Alternate OEM numbers: 47434188, 87486189.

Get help to fix this fault by requesting a quote

Browse other Case IH codes