ENG219

Case IH ENG219 – ECU: Oil Level - Remote Reservoir Is Too Low

Issue description

Fault code ENG219 indicates that the oil level in a remote reservoir, typically the hydraulic or transmission oil system, has dropped below the minimum required threshold. The Engine Control Unit (ECU) logs this code based on signals from the reservoir's level sensor. Operating with low fluid can lead to inadequate lubrication, pump cavitation, or severe system performance issues. While often resolved by adding fluid, this code can also point to underlying problems such as external leaks, faulty level sensors, or internal hydraulic pump failures.

Applies to these machines

  • Magnum 7120
  • Magnum 7130
  • Magnum 7140
  • Magnum 7230
  • Maxxum 5130
  • Maxxum 5140
  • Puma
  • Farmall
  • Steiger
  • Axial-Flow 7120
  • Axial-Flow 8120
  • Axial-Flow 9120

Check the cause

  1. Verify hydraulic oil level by parking on a level surface, cleaning and checking the dipstick or sight glass (engine may need to be at low idle depending on model), and topping off with recommended fluid (e.g., Hy-Tran) if low.

  2. Inspect the tractor for external hydraulic oil leaks at lines, fittings, cylinder seals, and pump/filter housings.

  3. Check hydraulic oil condition for milky/foamy appearance (water/air), burnt smell (overheating), or metal shavings (component wear).

  4. Inspect hydraulic filters and suction screens for clogs that could restrict oil flow and cause pump cavitation.

  5. Visually inspect the hydraulic oil level sensor and its wiring harness for damage, corrosion, or loose connections.

Repair steps

  1. Address low fluid and leaks

    Top off the hydraulic fluid with recommended oil. Run the tractor to pressurize the system and re-check for leaks. Replace any damaged hoses, fittings, or seals.

  2. Replace hydraulic filters

    If filters are dirty or past their service interval, replace them with genuine OEM parts. Inspect and clean the suction screen inside the reservoir if accessible.

  3. Test and replace oil level sensor

    If fluid level is correct but the code persists, disconnect the sensor and test for continuity/resistance using a multimeter. Manually move the float to simulate fluid changes; replace the sensor if it does not respond correctly.

  4. Evaluate hydraulic pump

    If the reservoir level drops rapidly during operation under load, it may indicate excessive internal pump leakage. Have a qualified technician perform a hydraulic pressure and flow test to confirm if pump replacement is necessary.

Parts you might need

(11)
  • Also described as a hydraulic oil float. Fits Magnum 7120-7230 and Maxxum 5130-5140.

  • Hydraulic Oil Filter

    Model-specific. Use tractor serial number to find correct filter in the Case IH parts catalog.

  • Hydraulic Pump

    Model-specific. Requires technician diagnosis before replacement.

  • Hydraulic Fluid

    Use genuine Case IH Hy-Tran or an equivalent fluid that meets the manufacturer's specifications.

  • Fluid Level Sensor

    3934497

    Common Cummins fluid level sensor

  • Fluid Level Sensor

    2872768

    Updated 3-pin fluid level sensor

  • Fluid Level Sensor

    2872769

    Updated 3-pin fluid level sensor

  • Fluid Level Sensor

    4928568

    Updated 3-pin fluid level sensor

  • Fluid Level Sensor

    4065972

    Used on QSK series engines

  • Fluid Level Sensor

    3408653

    Used on QSK series engines

  • Fluid Level Sensor

    3974648

    Used on 6C8.3 / 6B5.9 based engines

Get help to fix this fault by requesting a quote

Browse other Case IH codes