Case IH ENG242 – ENG: Intermittent or Tampered Vehicle Speed Signal
Issue description
The Engine Control Module (ECM) has detected an intermittent connection, an abnormal rate of change, or a tampering event regarding the vehicle speed signal. If the ECM detects that the signal drops out, fluctuates erratically, or indicates an attempt to defeat the road speed governor (tampering), it logs this code. When active, the engine speed operating range is often limited, and features like Cruise Control and Gear-Down Protection are disabled.
Applies to these machines
20 machines- Magnum 180
- Magnum 225
- Magnum 250
- Magnum 280
- Magnum 310
- Magnum 340
- Magnum 380
- Puma 165
- Puma 200
- Puma 240
- Maxxum 115
- Maxxum 125
- Maxxum 145
- Maxxum 150
- Steiger
- Quadtrac
- Farmall
- Axial-Flow
- Steiger 480
- Puma 165 CVXDrive
Check the cause
Retrieve all fault codes using the diagnostic display to identify any other related active or stored codes that might pinpoint the root cause.
Visually inspect the vehicle speed sensor wiring harness and connectors for physical damage, frayed wires, melted insulation near hot components, or moisture and corrosion inside connectors.
Determine the active speed source (radar vs. transmission sensor). If equipped with a radar unit, try unplugging it to see if the system defaults to the transmission sensor and clears the fault.
Remove and inspect the speed sensor and tone ring. Clean metallic debris from the sensor's magnetic tip and check the tone ring for broken or bent teeth.
Test the sensor circuit using a multimeter: check for continuity in the harness, verify correct power and ground voltage at the sensor, and measure sensor resistance (expected values vary by sensor type, commonly ~3000 ohms or 120-280 ohms).
Repair steps
Isolate the Faulty Component
Based on the diagnostic checks, determine if the fault lies with the sensor, the wiring, or the controller.
Address Wiring Issues
If a wiring problem is found, repair the damaged section of the harness or replace the faulty connector. Ensure all connections are clean and secure.
Sensor Adjustment/Replacement
If the sensor was just dirty or improperly installed, clean and reinstall it. Proper adjustment is critical: screw the sensor in until it touches the tone ring, then back it out 1/8 to 1/4 of a turn before tightening the locknut. If the sensor is confirmed to be faulty through testing, replace it with a new OEM or equivalent part.
Clear Fault Codes
After the repair is complete, clear the fault codes from the system using the onboard diagnostics or an external service tool.
Verify the Repair
Operate the machine to confirm that the fault code does not return and that the speedometer and other speed-dependent functions are operating correctly.
Parts you might need
(7)Transmission Speed Sensor
47130773Fits various Magnum, Maxxum, and Puma tractors. Supersedes 47766973, 87564756, 84169162, 5180162, 5190953, 82028157.
- Transmission Speed SensorA186004
Output shaft housing sensor for Steiger 480 tractors.
- Gear Speed Sensor87449451
Listed for Steiger tractors.
- Transmission Speed Sensor47942959
Fits various Case IH models.
- Transmission Speed Sensor47767008
Listed for Puma 165 CVXDrive tractors.
- Radar Ground Speed Sensor87733890
Fits Quadtrac models (may be discontinued).
Vehicle Speed Sensor (VSS) / Speed Pickup Sensor
609511Generic agricultural cross-reference example; specific Case IH serial number is required to pull the exact OEM part number.
Get help to fix this fault by requesting a quote