F-102-01 - ECU

Case IH F-102-01 - ECU – Engine ECU (A-095): Intake manifold pressure sensor voltage is lower than expected.

Issue description

The control module is detecting that the voltage signal returning from the intake manifold pressure sensor (MAP/boost sensor) has dropped below the normal calibrated range. This typically indicates a short to ground in the sensor wiring, a disconnected line, or an internal failure of the sensor itself.

Applies to these machines

  • MAGNUM AFS Connect
  • 240 Series Axial-Flow Combines (7240, 8240, 9240)
  • 250 Series Combines (7250, 8250, 9250)
  • Magnum Series Tractors (MX210, MX230, MX255, MX285)
  • Farmall Series Tractors (40, 45, 50 with Cab/CVT)

Check the cause

  1. Verify that the machine battery has not been connected to an external power supply (like a jump box or external charger), as voltage irregularities can trigger this code

  2. Check the sensor harness for a shorted to low source or a disconnected line

  3. Look for rubbed wires or corrosion at the sensor connector

  4. Check the Engine ECU (A-095) for the appropriate software version

Repair steps

  1. Turn off the machine and disconnect any external power supplies.

    Ensure the machine is off and any jump box or external charger is disconnected.

  2. Locate the intake manifold pressure sensor.

    Find the sensor on the engine's intake manifold.

  3. Disconnect and inspect the sensor connector.

    Disconnect the 4-pin connector and inspect for moisture, bent pins, or corrosion.

  4. Test the wiring harness.

    Test the wiring harness for continuity and ensure there is no short to ground.

  5. Replace the intake manifold pressure sensor.

    If the wiring is good but the voltage remains lower than expected, replace the intake manifold pressure sensor.

  6. Perform a post-repair reset.

    Once the physical issue is resolved, connect the Case IH Electronic Service Tool (EST). Navigate to the configure menu and perform the 'Engine Restart Counter Reset / Unlock Inducement' configuration to clear the derate/inducement state. Return the machine to service.

Parts you might need

(9)
  • Engine Intake Manifold Pressure Sensor

    504307953

    CNH / Case IH OEM Part. 4-pin connector, 50 to 400 kPa range. Ensure replacement includes a new sealing O-ring.

  • Engine Intake Manifold Pressure Sensor

    2852821

    CNH / Case IH OEM Part

  • Engine Intake Manifold Pressure Sensor

    84286249

    CNH / Case IH OEM Part

  • Engine Intake Manifold Pressure Sensor

    026123001A

    Bosch (OEM Supplier)

  • Engine Intake Manifold Pressure Sensor

    0281006049

    Bosch (OEM Supplier)

  • Engine Intake Manifold Pressure Sensor

    0281006288

    Bosch (OEM Supplier)

  • Engine Intake Manifold Pressure Sensor

    AD-188045

    Akusan (Aftermarket Alternative)

  • Engine Intake Manifold Pressure Sensor

    15096

    FAE (Aftermarket Alternative)

  • Engine Intake Manifold Pressure Sensor

    37055

    FEBI BILSTEIN (Aftermarket Alternative)

Get help to fix this fault by requesting a quote

Browse other Case IH codes