NH2091

Case IH NH2091 – TCU: C3 Clutch Not Calibrated

Issue description

The C3 clutch pack within the powershift transmission is not properly calibrated. The Transmission Control Unit (TCU) has lost the stored calibration values that determine the precise amount of electrical current required to operate the clutch's solenoid for smooth and timely engagement. Without these values, the transmission system's functionality is affected and may experience hard or erratic shifting.

Applies to these machines

  • Mid-range Magnum series (including Legacy models)
  • Puma series
  • MXU115
  • MX Magnum series
  • Magnum 340
  • Steiger 580

Check the cause

  1. Check for and resolve any other active transmission-related fault codes, especially those indicating solenoid or sensor failures (e.g., open circuits, shorts), as they will prevent successful calibration

  2. Ensure the tractor is parked on a flat, level surface with the parking brake engaged and the area clear of personnel or obstacles

  3. Verify the transmission hydraulic oil is warmed to a minimum operating temperature of above 60°C (140°F)

  4. Ensure the engine is running at a stable speed, typically around 1200 RPM, as prompted by the calibration menu

Repair steps

  1. Enter Calibration Mode

    With the tractor's key off, press and hold the specific calibration button combination on the armrest console (e.g., upshift/downshift rocker, program button, or rabbit/turtle buttons) while turning the key to the 'on' position and starting the engine.

  2. Navigate to Transmission Menu

    Once the diagnostic or configuration menu appears on the display, navigate to the transmission settings (often labeled 'TCU', 'TRANS SETUP', or similar).

  3. Select Clutch Calibration

    Within the transmission menu, locate and select the 'Clutch Calibration' (or 'Cltch Cal') option.

  4. Follow On-Screen Prompts

    Follow the system prompts to verify oil temperature, set engine RPM, and place the shuttle lever in the forward position.

  5. Initiate Calibration

    Start the calibration process. The system will automatically cycle through each clutch pack (C1, C2, C3, C4, etc.), measuring the current required for engagement. Monitor the display for completion values.

  6. Complete and Save

    Continue until all required clutches are calibrated and the display shows an 'END' or 'Exit' message. Turn the tractor's key to the 'off' position to save the new calibration values.

Parts you might need

(4)
  • C3 clutch solenoid

    Only required if calibration fails repeatedly, indicating a component failure.

  • C3 clutch pack

    Only required if calibration fails repeatedly, indicating a mechanical or hydraulic issue.

  • Fitment depends heavily on the specific model/year

  • Clutch 3 Actuating Tube / Pipe

    228814A1

    Fitment depends heavily on the specific model/year

Get help to fix this fault by requesting a quote

Browse other Case IH codes