Case IH NH3004: Accelerator Pedal Signal - NO SIGNAL

The system has detected that there is no signal being received from the accelerator pedal. This may prevent the machine from responding properly to operator input.

1. 1

   Accelerator Pedal

2. 2

   Wiring to Accelerator Pedal

3. 3

   Controller Input for Accelerator Pedal

1. 1

   Inspect

   Check the accelerator pedal for physical damage or improper installation.

2. 2

   Test

   Verify the electrical connection between the accelerator pedal and the controller.

3. 3

   Measure

   Use a multimeter to check for proper voltage or signal output from the accelerator pedal.

4. 4

   Replace

   If the accelerator pedal is faulty, replace it with a compatible component.

5. 5

   Reset

   After repairs, reset the controller to clear the fault code and test the system.