NH3117

Case IH NH3117 – ECU: ECU Self Test Shutoff Paths (Start Up) - Not Plausible

Issue description

The ECU has detected an anomaly during its power-down self-test shutoff paths process at the previous shutdown, logging the fault at the next start-up. This fault is classified as not plausible, and the engine will be derated to 1800 RPM as a protective measure. The underlying condition is typically an issue with the ECU's power supply, most frequently caused by the ECU losing power while the engine was running or an incorrect shutdown procedure that interrupts the ECU's ability to purge systems and save operational data.

Applies to these machines

  • Puma 150
  • Puma 165
  • Puma 180
  • Puma 200
  • Puma 220
  • Puma 240
  • Magnum 180
  • Magnum 200
  • Magnum 220
  • Magnum 240
  • Magnum 250
  • Farmall 35A

Check the cause

  1. Review the shutdown procedure to confirm the operator is waiting several minutes after key-off before activating a battery disconnect switch.

  2. Inspect battery terminals and main power/ground cables to the chassis and engine block for security, cleanliness, and corrosion.

  3. Check the main fuse panel for blown fuses related to the Engine Control Unit (e.g., 5A or 10A Engine Control fuses).

  4. Inspect the main power relay for the ECU and its socket for signs of melting, corrosion, or damage.

  5. Visually inspect the wiring harness leading to the ECU for chafing, melting, or corrosion at the connectors, paying close attention to routing near hot or moving parts.

Repair steps

  1. Clear the fault code

    Turn the tractor completely off, wait several minutes, and restart to see if the intermittent fault clears. Alternatively, disconnect the battery for an hour to reset the ECU's memory.

  2. Replace fuses and relays

    If diagnostic checks reveal blown fuses, replace them with new ones of the same amperage. If the ECU relay is suspected, swap it with an identical non-critical relay; if the fault resolves, install a new relay.

  3. Repair wiring harness

    Repair any damaged sections of the ECU wiring harness and clean any corroded connectors with an appropriate electrical contact cleaner.

  4. Replace the ECU

    If all power supply circuits, grounds, fuses, and relays are confirmed good and the fault persists, replace the ECU. This is a last resort and requires programming by a certified dealer using the Electronic Service Tool (EST).

Parts you might need

(5)
  • Example part number for DX33 (replaces 86537972). Verify fitment by serial number.

  • Fuse (7.5A)

    89623776

    Example part number. Verify exact amperage needed for your machine.

  • Fuse (20A)

    87693743

    Example part number. Verify exact amperage needed for your machine.

  • Example for Puma 160 (40KPH). Remanufactured option: 84374397R. Requires dealer programming.

  • Engine Control Unit (ECU)

    84374396

    Example for Puma 160 (50KPH). Requires dealer programming.

Get help to fix this fault by requesting a quote

Browse other Case IH codes