Case IH NH4141 – Hydraulic or Transmission Control Module: Remote No.3 Spool Not In Neutral
Issue description
The electronic control system has detected that the spool for the number three remote hydraulic valve is not in its neutral position when the tractor's ignition key is turned on. This is a safety mechanism designed to prevent unexpected hydraulic implement activation upon startup. The underlying condition may be a mechanical issue with the valve spool sticking, a faulty electronic spool position sensor, or a calibration loss within the hydraulic control module.
Applies to these machines
10 machines- Puma
- Maxxum
- Optum
- Magnum
- Steiger
- T7.220
- T7.235
- T7.250
- T7.260
- T7.270
Check the cause
Visually ensure the remote valve lever for remote #3 is physically in the neutral position and check for any obstructions or debris preventing return to neutral.
Inspect the wiring and connectors associated with the #3 remote valve for visible damage, corrosion, or loose connections.
Verify battery voltage and charging system health, as low system voltage can trigger erroneous fault codes.
Use a diagnostic scanner or the tractor's display menu to confirm NH4141 is an active fault.
Perform a basic hydraulic function test on remote valve #3 to check for correct response, sluggishness, or failure to detent.
Check for internal leaks by installing a low-pressure gauge on the drain circuit of the valve block and actuating each remote to monitor for pressure increases.
Repair steps
Calibrate remote valve
Re-calibrate the remote valve to restore synchronization between the control lever and the valve. Access calibration mode via the tractor's display menu, set flow control to maximum, and move the lever through its full range. For armrest controls, turn the key on while pressing the program button, navigate to aux lever settings, and move levers as prompted. (Note: Some models like the MX210 may require calibration tool CAS2806).
Calibrate EDC valve
If a new Electronic Draft Control (EDC) valve or control module has been recently installed, perform an EDC valve calibration through the service menu on the tractor's display.
Inspect and repair remote valve mechanically
If calibration fails, remove the valve spool from the valve body. Inspect the spool, detent components (springs, balls, piston), and seals for wear, damage, or debris. Replace worn parts and reassemble using a suitable assembly lube like Vaseline (do not use grease to avoid hydraulic contamination).
Parts you might need
(7)Remote Hydraulic Valve Assembly
A169029OEM part number for older models like the Case 2090 series
- Remote Hydraulic Valve Assembly87526168
OEM number for New Holland T7 series
Remote Hydraulic Valve Assembly
521 610 025Bosch number for New Holland T7 series
3rd Remote Valve Kit
719357595Includes control valve, couplers, and lever
- Spool Position Sensor84386295
Detects spool position for the control valve
Communicates oil pressure to the ECU (applicable to T6/T7 series)
Remote Valve Seal Kit
Specific to valve model, required for rebuilding the remote valve
Get help to fix this fault by requesting a quote