Case IH NH4166 – EHR: Rear Remote No.5 Output Stage Faulty
Issue description
The fault code indicates an electrical problem within the circuit controlling the fifth rear hydraulic remote valve. The EHR (Electro-Hydraulic Remote) controller has detected an anomaly such as a short circuit, an open circuit, or another electrical issue in the wiring or the solenoid coil for the number 5 remote valve. This prevents the output stage of the controller from sending power to the solenoid, resulting in the inability to operate any implement connected to that specific remote.
Applies to these machines
8 machines- Magnum 210
- Magnum 235
- Magnum 340
- STX Steiger 350
- STX Steiger 600
- Puma
- Quadtrac
- MX
Check the cause
Verify if the fault is active or stored, and check for related codes (e.g., 4167, 4168, 4169) that might indicate sensor or stuck spool issues.
Visually inspect the wiring harness and connectors leading to the No. 5 remote valve for chafing, corrosion, or loose pins.
Perform a solenoid voltage test: measure DC voltage across the solenoid wires while moving the remote lever (should increase from 0V in neutral to approximately 5V at full detent). If voltage is correct but the valve doesn't actuate, the pilot head is likely faulty. If no voltage is present, suspect the wiring or EHR controller.
Swap the electronic pilot head from remote No. 5 with a known good one from an adjacent remote to see if the fault code follows the component.
With the pilot head removed, manually press the end of the valve spool with your thumb to ensure it moves freely and is not mechanically binding.
Check if the issue can be resolved with a software update and recalibration; calibration can sometimes be performed through the tractor's display, but updating software typically requires dealer intervention with the EST.
Repair steps
Relieve hydraulic pressure
Relieve all hydraulic pressure from the system.
Disconnect electrical connector
Disconnect the electrical connector from the pilot head of remote valve No. 5.
Remove pilot head assembly
Unbolt and remove the pilot head assembly from the main hydraulic valve body.
Install new pilot head
Install the new pilot head, ensuring any seals or O-rings are correctly seated.
Torque bolts
Torque the bolts to the manufacturer's specification.
Reconnect electrical connector
Reconnect the electrical connector.
Calibrate and test
Start the tractor and perform a remote valve calibration procedure as required by the service manual or through the instrument cluster. Test for proper operation.
Parts you might need
(7)- Standard Pilot Head Valve47643919
Supersedes 84139664, 84478195, 87577686, 47434056. Fits Magnum, Puma, Quadtrac, and Steiger.
Supersedes 87383670, 87383671. Fits Magnum, MX, Puma, T7, T8000.
- Solenoid Valve87681738
Alternative solenoid valve part number.
- Remote Valve Wiring Harness87748970
Example harness part number; verify exact fitment by serial number.
Hydraulic Valve Manifold
404434A1STX450 example
- Electronic Remote Valve Slice48012370
Puma/Magnum examples
EH Remote Slice Kit
719411274Puma/Magnum examples
Get help to fix this fault by requesting a quote