NH5099

Case IH NH5099 – ACM: Auto PTO Mode Not Enabled

Issue description

The system indicates that the Auto PTO mode is not enabled, preventing the proper automatic operation of the power take-off system. This means the conditions required to activate the Automatic PTO function (which automatically disengages the PTO when the three-point hitch is raised and re-engages it when lowered) have not been met, or a fault exists within the system preventing its engagement.

Applies to these machines

  • Case IH Puma Series
  • Case IH Farmall U Series
  • Case IH Farmall M Series
  • Case IH AFS Connect Magnum

Check the cause

  1. Verify operator procedure: ensure the operator is manually engaging the PTO and then pressing the Auto PTO button while the tractor is stationary and the PTO is switched off before setting engagement/disengagement heights

  2. Check switch status at power-up: cycle all PTO-related switches (cab switch, Auto PTO switch, remote fender switch) to the 'off' position, then power-cycle the tractor to clear active switch faults

  3. Inspect basic tractor conditions: check transmission fluid level, inspect transmission oil filter for blockages, and confirm the operator is seated to satisfy the seat switch interlock

  4. Verify hitch and speed parameters: ensure tractor speed or stationary time limits are not exceeding Auto PTO operational parameters

  5. Check for other active faults related to the PTO system, hitch position sensors, or armrest controller (e.g., PTO engagement switch, PTO speed sensors, or hitch position potentiometer)

Repair steps

  1. Inspect Auto PTO Switch

    Test the 'Auto PTO' switch on the armrest controller for proper electrical function (continuity and resistance) using a multimeter. Replace if stuck or faulty.

  2. Inspect PTO Engagement and Speed Sensors

    Locate and inspect the PTO speed sensors (typically two on dual-PTO tractors) and their wiring for damage or contamination. Ensure their speeds match.

  3. Inspect PTO Control Solenoid

    Locate the PTO control solenoid valve near the rear hydraulic remote valves. With the tractor off, disconnect the coil and test resistance (infinite resistance indicates a failed coil). Check for power and ground at the connector when the PTO is commanded on.

  4. Calibrate the PTO System

    Access the tractor's diagnostic 'H' menu to calibrate the rear PTO clutch. This procedure may be necessary if the Transmission Control Unit (TCU) has been replaced or if calibration values have been erased. Ensure the engine and transmission are at the specified operating temperature before performing the calibration.

  5. Inspect and Test Wiring Harness

    Carefully inspect the wiring harness between the armrest controller, PTO switches, sensors, and the PTO control solenoid for any signs of damage, corrosion, or loose connections.

Parts you might need

(7)
  • Auto PTO Switch

    Push button switch on armrest

  • PTO Control Solenoid/Coil

    PTO control solenoid coil

  • PTO Speed Sensor

    Speed sensor for PTO feedback

  • Hitch Position Sensor

    Hitch potentiometer

  • Armrest Control Module

    Armrest ECU (if internal fault is diagnosed)

  • Control Lever

    84146517

    For mechanically actuated components

  • Cable84146525

    For mechanically actuated components

Get help to fix this fault by requesting a quote

Browse other Case IH codes