Case IH TMF58: Left Draft Pin Voltage Out of Specification During Calibration

The voltage of the Left Draft Pin is not within the specified range when no load is applied during the calibration process. This indicates a potential issue with the electrical signal integrity or the component associated with the Left Draft Pin.

1. 1

   Left Draft Pin wiring connections

2. 2

   Left Draft Pin sensor or circuit

3. 3

   Calibration procedure and settings

1. 1

   Inspect

   Check the wiring connections for the Left Draft Pin for damage, corrosion, or loose connections.

2. 2

   Test

   Measure the voltage of the Left Draft Pin during calibration to confirm it is outside the specified range.

3. 3

   Verify

   Ensure the calibration procedure is being performed correctly and that the system is in the no load condition as required.