Case IH TMF60: Draft Pin Connection Mismatch During Calibration

The draft pin is connected to the left side instead of the right side for a single pin setup during calibration. This misalignment may affect the proper operation of the system during calibration procedures.

1. 1

   Position of the draft pin relative to the left and right sides

2. 2

   Calibration setup configuration

3. 3

   Connection of the draft pin as per the specified single pin setup

1. 1

   Verify the draft pin connection

   Ensure the draft pin is connected to the correct side as specified for the single pin setup during calibration.

2. 2

   Adjust the draft pin position

   If the draft pin is connected to the left side, reposition it to the right side as required for the single pin setup.

3. 3

   Recheck the calibration setup

   After adjusting the draft pin, recheck the calibration setup to confirm the correct configuration.