E190

Challenger E190 – ECM / PCU: Signal Engine Speed Issue

Issue description

The electronic control system has detected a problem with the signal from the engine speed sensor, which may involve an abnormal frequency, pulse width, or period. This loss or corruption of the engine speed signal can lead to erratic engine behavior, sputtering, or complete engine shutdown.

Applies to these machines

  • MT665B

Check the cause

  1. Review active and stored fault codes on the TMC display for related errors (e.g., code 66, E9070, E9071, E9072, E9090)

  2. Inspect the wiring harness between the control unit (ECM/PCU) and the engine speed sensor for any signs of damage, corrosion, or loose connections

  3. Inspect the engine speed sensor itself for any visible damage

  4. Check for other fault codes related to components like the fuel filter, water in fuel, oil pressure, and coolant temperature, as they can sometimes cause erratic engine behavior

Repair steps

  1. Locate the engine speed sensor

    On models like the MT665B, the sensor is located at the back of the engine reading off the flywheel. On CAT C7 and C9 engines, there are typically two timing sensors located between the air compressor and the HEUI pump.

  2. Inspect and clean connections

    Disconnect the wiring harness from the sensor and the ECM/PCU. Inspect the pins and connectors for corrosion or damage. Clean the contacts and ensure a secure connection.

  3. Test the wiring

    Test the continuity and insulation of the wiring harness between the sensor and the control module to rule out a break or short in the wires.

  4. Replace the engine speed sensor

    If the wiring tests good and the connections are clean but the fault persists, replace the engine speed sensor.

  5. Replace ECM/PCU

    If replacing the wiring harness and the sensor does not resolve the issue, the root cause may be a failure in the Engine Control Unit itself.

Parts you might need

(4)
  • Engine Speed Sensor

    72624518

    AGCO OEM part

  • Monitors rotational speed and position of the crankshaft

  • Transmitter Engine Speed Sensor

    F339202210180

    AGCO OEM part

  • Speed Sensor

    577941D1

    AGCO OEM part

Get help to fix this fault by requesting a quote

Browse other Challenger codes