E9071

Challenger E9071 – ECU: Signal Engine Speed Issue

Issue description

The Engine Control Unit (ECU) is receiving an erratic, intermittent, or implausible signal from the crankshaft speed sensor, often described as 'too much noise pulses'. This prevents the ECU from accurately determining the engine's speed and crankshaft position, which can lead to symptoms such as the engine cranking but not starting, sudden stalling, rough running, or the emission of white smoke.

Applies to these machines

  • MT535B
  • MT665B

Check the cause

  1. Check for other fault codes (such as CAN bus error E639) that may indicate a broader electrical or communication problem

  2. Inspect the wiring harness and connectors leading to the crankshaft position sensor for chafing, melting, corrosion, or loose pins

  3. Check main battery connections and chassis/engine ground straps to ensure they are clean and tight, as poor power/ground can cause erratic sensor readings

  4. Test the internal resistance of the crankshaft speed sensor with a multimeter and compare to manufacturer specifications

  5. Verify if an 'Engine Speed/Timing Sensor - Calibrate' procedure is required, especially if the ECU was recently replaced or timing is off

  6. Use AGCO's dealer-level tool, Tech Connect Diagnostics (TCD), for comprehensive diagnostics

Repair steps

  1. Locate the sensor

    Consult the service manual for the exact location. Common locations include the flywheel housing, side of the engine block, front timing cover, or bell housing.

  2. Disconnect battery

    Disconnect the negative battery terminal for safety before beginning work.

  3. Remove the old sensor

    Disconnect the electrical connector. Remove the mounting bolt(s). Gently twist and pull the sensor to remove it from its bore. Do not pry it out with a screwdriver to avoid damaging the mounting surface.

  4. Install the new sensor

    Clean the mounting surface. Apply a light coat of clean engine oil to the new sensor's O-ring. Insert into the bore, tighten mounting bolts to specified torque (do not overtighten), and reconnect the electrical connector.

  5. Finalize repair

    Reconnect the battery, start the engine to confirm the ECU recognizes the new sensor, and clear any stored fault codes using a diagnostic tool.

  6. Replace ECU (if necessary)

    If replacing the sensor and wiring harnesses does not resolve the issue, the Engine Control Unit (ECU) itself may be faulty and require replacement.

Parts you might need

(1)
  • Inductive sensor that reads a trigger wheel mounted on the crankshaft. Used across various AGCO Power engines.

Get help to fix this fault by requesting a quote

Browse other Challenger codes