7513h

CLAAS 7513h – MFA (A100): Signal Voltage Issue on Axis 4 of the Cross Command

Issue description

The signal voltage from the sensor corresponding to Axis 4 of the cross command lever is outside of expected parameters. This incoherent or invalid voltage reading typically indicates an issue with the potentiometer within the joystick, which may affect the proper operation of the component or system linked to this signal.

Applies to these machines

  • Axion
  • Axion 850
  • Arion

Check the cause

  1. Verify the fault code using a compatible diagnostic tool, such as the CLAAS Diagnostic System (CDS).

  2. Perform a general electrical system check to ensure stable battery voltage and check for any other system-wide electrical fault codes.

  3. Inspect the electrical connections and wiring harness between the cross command lever and the MFA (A100) module for loose or corroded connectors, damaged wires, or moisture intrusion.

  4. Check the wiring harness to the electrodistributor n° 4 (R75) for continuity and short circuits.

  5. Measure the resistance of the potentiometer for Axis 4 while moving the lever. The reading should change smoothly; erratic readings indicate a worn or faulty potentiometer.

Repair steps

  1. Access the joystick assembly

    Disconnect the tractor's battery. Remove the necessary covers on the multifunction armrest to gain access to the cross command lever assembly. Label all electrical connectors before disconnecting them.

  2. Disassemble the joystick

    Carefully disassemble the joystick housing to access the internal potentiometers, which are typically soldered to a circuit board inside.

  3. Replace the potentiometer

    Identify the potentiometer corresponding to Axis 4 (may require tracing wires from the R75 electrodistributor). Desolder the faulty potentiometer from the circuit board and solder the new replacement in its place, ensuring correct orientation.

  4. Reassemble and calibrate

    Reassemble the joystick and the armrest. Perform a joystick calibration through the machine's service menu using a diagnostic tool so the ECU learns the new potentiometer's full range of motion and neutral position.

  5. Clear fault codes and test

    Reconnect the battery, clear the fault codes using a diagnostic tool, and test the function of the cross command lever to ensure the issue is resolved.

Parts you might need

(4)
  • CLAAS Potentiometer

    0111100

    Specific application not confirmed; verify fitment with dealer

  • Listed for Lexion harvesters; may not be compatible with Axion/Arion

  • C-Motion drive lever assembly

    5005150008

    Complete unit replacement option if component-level repair is not feasible

  • Joystick Potentiometer / Position Sensor

    Generic replacement; match resistance value (e.g., 5kΩ, 10kΩ) and physical specifications if OEM part is unavailable

Get help to fix this fault by requesting a quote

Browse other CLAAS codes