CLAAS 752Fh: Voltage of the signal specified by the stop sequence too high contact

The voltage of the signal specified by the stop sequence is too high, which has caused the Claas Sequence Management to become inactive.

1. 1

   The signal specified by the stop sequence

2. 2

   The contact associated with the signal

3. 3

   The voltage level of the signal

1. 1

   Check the signal specified by the stop sequence

   Verify that the signal is functioning correctly and is not producing an abnormal voltage.

2. 2

   Inspect the contact associated with the signal

   Look for any signs of damage, wear, or poor connection that could be causing the voltage to be too high.

3. 3

   Measure the voltage of the signal

   Use a multimeter or other appropriate tool to measure the voltage and confirm it is within the expected range.