7584h

CLAAS 7584h – SFA: No Message from Right Shock Absorber

Issue description

A communication failure has occurred within the active cab suspension system. The Suspended Front Axle (SFA) central control module has not received a signal from the right-hand cab shock absorber electronic module (A139) within five seconds of machine startup. This indicates a fault in the data link, the shock absorber's control module, or associated wiring. As a safety precaution, the system defaults to a 'hard mode' (disabling active dampening) and may limit the tractor's maximum speed to 15 km/h.

Applies to these machines

  • Axion 800
  • Axion 850

Check the cause

  1. Restart the machine to determine if the communication error is intermittent or persistent

  2. Visually inspect the right-hand rear of the cab for obvious damage to the shock absorber, wiring harness, or connectors (look for debris, corrosion, or rodent damage)

  3. Inspect the Z-Activ CAN bus wiring harness for chafed, pinched, or broken wires

  4. With power off, measure resistance between CAN High and CAN Low at a connector (should be approx. 60 Ohms; 120 Ohms indicates a missing termination resistor or broken wire)

  5. With power on, measure CAN bus voltage relative to ground (CAN High should be 2.5-3.0 V; CAN Low should be 2.0-2.5 V)

  6. Inspect electrical connectors at the main SFA (A102) module and the right-hand cab suspension module (A139). Disconnect, check for corrosion or bent pins, clean with contact cleaner, and securely reconnect

  7. Verify reliable power supply and ground connections to the A139 module

Repair steps

  1. Confirm fault codes

    Use the CLAAS Diagnostic System (CDS) to read all fault codes and confirm that 7584h is active. Note any other related CAN bus or module communication errors.

  2. Repair wiring and connectors

    If visual inspection or multimeter tests reveal damage to the Z-Activ CAN bus wiring harness or connectors, repair or replace the faulty section. Clean pins with contact cleaner and ensure secure connections.

  3. Test shock absorber module (A139)

    If wiring is intact, swap the left and right shock absorber modules. If the fault code changes to indicate a failure on the left side, the A139 module is confirmed faulty.

  4. Replace faulty module

    Replace the A139 module if identified as the cause. If the fault persists after replacing A139 and verifying wiring, replace the main SFA (A102) control unit as a last resort.

  5. Calibrate and verify system

    After replacing any component, clear all fault codes using the CDS. Perform a system calibration or reconfiguration so the new module is recognized by the network, then operate the machine to verify the repair.

Parts you might need

(3)
  • Alternative part numbers include 7700058103 and 002 22386171. The electronic module may be integrated with the shock absorber as a single unit.

  • SFA Control Module (A102)

    0145371

    Alternative part numbers include 18111314 and 8350541. Replacement of this central controller should only be considered after all other possibilities are exhausted.

  • Cab Suspension Sensor

    704143A1

    Cross-references McCORMICK 704143A1, CASE 704143A1, ELOBAU 424A16B090. Verify correct part number for specific tractor model and serial number.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes