75CDh

CLAAS 75CDh – TR2: Loss of ENG module engine speed information

Issue description

The TR2 transmission control module has lost the engine speed signal from the ENG (engine control module) or direct engine speed sensors via the CAN bus network. This data is critical for transmission and power management functions. When this signal is lost, the system typically defaults to the lowest power curve as a safety measure.

Applies to these machines

  • Arion 640
  • Arion 650
  • Arion 510
  • Arion 530
  • Jaguar
  • Lexion
  • Quadrant

Check the cause

  1. Visually inspect CAN bus connectors for moisture ingress, corrosion, or physical damage, especially under the cab floor which are vulnerable to rain if the rear window is left open

  2. Measure CAN bus termination resistance with power off (should be approximately 60 Ohms between CAN High and CAN Low)

  3. Check CAN bus voltage with power on (look for abnormal readings like below 1.4V or a static 2.5V)

  4. Check the adjustment of the engine speed sensors (e.g., B228-1 and B228-2)

  5. Visually inspect engine speed sensors and wiring for physical damage, fraying, or melting

  6. Perform a resistance test on magnetic engine speed sensors to check for open circuits or out-of-spec readings

  7. Perform a signal generation test by back-probing the sensor signal wire while rotating the engine component

  8. Review other active fault codes to rule out a broader electrical or CAN bus failure

Repair steps

  1. Verify the fault

    Start the machine and check if the fault code is active. Note any other fault codes present.

  2. Inspect CAN bus connectors

    Visually inspect all major CAN bus junction blocks and connectors for corrosion or damage. Clean and secure any suspect connections.

  3. Test CAN bus electrical properties

    Perform the 60 Ohm termination resistance test with the power off. If the reading is incorrect (e.g., 120 Ohms or open/shorted), trace the wiring to find the fault.

  4. Locate and inspect engine speed sensors

    Inspect key speed sensors and their harnesses. On Arion tractors, these include B228-1 (PTO clutch housing), B228-2 (gearbox entry shaft), and B231 (crankshaft position).

  5. Test the suspect sensor

    Perform resistance and signal generation tests on the engine speed sensors to determine if they are functioning correctly.

  6. Replace faulty components

    Replace any identified faulty sensor with a new OEM part. Repair or replace damaged CAN bus wiring harnesses, or replace the control module if its CAN port is faulty.

  7. Clear faults and re-test

    After completing repairs, clear all fault codes using a diagnostic tool and operate the machine to ensure the fault does not return.

Parts you might need

(3)
  • Listed for CLAAS Jaguar and Quadrant models. Alternate part number: 00118153.

  • Listed for CLAAS Lexion and Jaguar series harvesters. Alternate part numbers: 0000117991, 0000117992.

  • Listed for CLAAS Jaguar harvesters. Alternate part number: 011810.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes