CLAAS 75E4h – A57-1 TR1: Inconsistency Between Selected Gear and Measured Ratio
Issue description
The system detects an inconsistency between the selected gear and the actual gear ratio being measured by the transmission control module. This indicates a problem within the HEXASHIFT transmission's range-shifting mechanism, where the electronic command to shift into a specific range (A, B, C, or D) does not match the mechanical feedback. This can be caused by faulty range sensors providing incorrect data, wiring issues interrupting the signal, or mechanical failures preventing the gear change from completing.
Applies to these machines
3 machines- Arion 500
- Arion 600
- Axion 800
Check the cause
Inspect the wiring harness and CAN bus connectors associated with the transmission range sensors and the A57-1 TR1 module for corrosion, damage, loose connections, or moisture ingress
Check the A, B, C, and D range engaged contacts (Z153-1, Z153-2, Z153-3, and Z153-4) for incorrect signals
Inspect for mechanical faults in the range selection module (listen for a crunching noise when shifting from D to C range, which indicates a failing C-range bearing)
Check if degraded shift quality necessitates a transmission calibration
Repair steps
Retrieve All Fault Codes
Use a diagnostic tool to read all active and stored fault codes from the transmission control module. This can provide additional context to the 75E4h code.
Perform Diagnostic Checks
Follow the diagnostic steps outlined above to identify the source of the fault.
Address Sensor or Wiring Issues
If a faulty range sensor (Z153 contact) or a wiring issue is identified, replace the faulty component or repair the wiring.
Address Mechanical Issues
If a mechanical issue, such as a worn C-range bearing, is suspected, the transmission will require disassembly for inspection and repair. This is a complex task that should be performed by a qualified technician.
Perform Transmission Calibration
After any repairs to the transmission, especially those involving the replacement of sensors or mechanical components, a transmission calibration should be performed according to the manufacturer's instructions.
Clear Fault Codes and Test
After completing the repairs and calibration, clear all fault codes and operate the tractor to ensure the issue has been resolved.
Parts you might need
(6)- Transmission Speed Sensor0000118153
Aftermarket part number. While not directly implicated, a faulty speed sensor can cause related transmission issues.
Transmission Speed Sensor
00118153Aftermarket part number. While not directly implicated, a faulty speed sensor can cause related transmission issues.
Range Engaged Contact/Sensor (Z153)
Crucial for detecting the selected range. Consult dealer for specific part number.
A57-1 TR1 Transmission Control Module
Required only in the event of internal module failure. Consult dealer for specific part number.
HEXASHIFT Transmission Bearings
C-range bearing may be required if mechanical failure is the root cause.
- Hexashift Solenoid Valve0011367040
Alternative/Short number: 1136704. Fitment: CLAAS Arion 500/600 series and Axion 800 series.
Get help to fix this fault by requesting a quote