7622h

CLAAS 7622h – TR2: High-Pressure Brake Pressure Fault

Issue description

This fault code indicates an issue within the high-pressure braking system where the hydraulic pressure is not decreasing as expected or is registering as too high. This condition suggests a potential hydraulic blockage, a faulty pressure sensor providing incorrect readings, or a malfunctioning control valve. When active, the system triggers a blinking brake indicator light to alert the operator.

Applies to these machines

  • Axion 800 Series
  • Axion 850-810 Series
  • Arion 640-510 Series

Check the cause

  1. Visually inspect all hydraulic lines, valves, and switches associated with the brake system for any signs of damage, leaks, or blockages

  2. Ensure all electrical connectors to the braking pressure sensor and solenoid valve are secure and free of corrosion, and check the wiring harnesses for any signs of damage, short circuits, or open circuits

  3. Use a diagnostic tool to monitor the live data from the braking pressure sensor (B233) to see if its readings are plausible

  4. Verify the voltage being supplied by the transformer (V24) to ensure it is within specification

Repair steps

  1. Replace braking pressure sensor

    If live data readings from the braking pressure sensor (B233) are implausible or indicate an internal fault, replace the sensor.

  2. Test and replace solenoid valve

    Test the high-pressure braking solenoid valve (Y329) for proper operation. If the valve is stuck closed or not actuating correctly (trapping pressure in the system), replace it.

  3. Test Auto 5 module

    If the sensor and solenoid are functioning correctly, test the 'Auto 5' control module using CLAAS diagnostic tool (n° 60 05 033 249). Repair or replace the module if found to be faulty.

Parts you might need

(3)
  • Possible candidate, requires confirmation with a CLAAS parts catalog or dealer.

  • High-Pressure Braking Solenoid Valve (Y329)

    6005029664

    Alternative part number 071329. Confirmation with a parts catalog is necessary.

  • "Auto 5" Control Module

    Typically a repairable unit; repair services are available.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes