CLAAS 763Ch – Claas Tr2 A57 2 Transmission Module: Problem Saving Parameters When Placing Units on Standby

The system is experiencing an issue where parameters are not being saved when units are placed on standby. This may be related to a loss of the permanent 12 V supply before the 12 V shutoff after the ignition is turned on. The system does not indicate an ISC reset request.

1. 1

   The permanent 12 V supply before 12 V shutoff after ignition is turned on

2. 2

   The component identified by this code

1. 1

   Check

   For a possible loss of the permanent 12 V supply prior to 12 V shutoff after switching on the ignition.

2. 2

   Change

   The component identified by this code to 'Auto 5' if the issue persists.