CLAAS Id7647h / 7647h (440) – TR2 (A57-2): Current consumed by solenoid valve SV3 is greater than 1.4 A

The current drawn by the transmission solenoid valve SV3 has surpassed the maximum permissible limit of 1.4 amps. This overcurrent condition triggers an audible alarm and necessitates an 'ISC' (Information System Control) reset. The underlying cause is typically an electrical fault, such as a short circuit in the wiring harness or an internal failure of the solenoid valve itself.

• Axion 850-810 series
• Arion 640-510 series

1. 1

   Check for a possible 12 V short circuit on the solenoid valve power supply harness

2. 2

   Check the solenoid valve SV3 (Component ID: Y335-3), identified as the Ratio under torque solenoid valve

3. 3

   Check the connectors and continuity of harnesses linking each component for short-circuits, open circuits, resistance, and energy sources (fuses, supply, and ground)

4. 4

   Check the 'Auto 5' module using CLAAS diagnostic tool n° 60 05 033 249

1. 1

   Document Codes

   Note all error codes present on the tractor and analyze any interactions (as one error code can generate another).

2. 2

   Inspect Wiring

   Visually and electrically inspect the power supply harness leading to solenoid valve SV3 (Y335-3) for a 12V short to power or ground. Repair any damaged wiring.

3. 3

   Test the Solenoid

   Measure the resistance of the SV3 solenoid valve winding to ensure it is within specification and not internally shorted (which would cause the current draw to exceed 1.4 A). Replace the solenoid valve if it fails the resistance test.

4. 4

   Test the Control Module

   If the wiring and solenoid are intact, use diagnostic tool n° 60 05 033 249 to test the "Auto 5" module.

5. 5

   Replace Components

   Change the "Auto 5" module or the solenoid valve if required based on the test results.

6. 6

   Clear and Verify

   Clear all error codes, then test drive the tractor to ensure the anomaly does not return.