765Ch

CLAAS 765Ch – ECM: Power Management Limitation due to High Coolant Temperature (Component 2)

Issue description

The engine's coolant temperature has reached a critical level, falling within the range of 105 °C to 113 °C. In response, the Claas Power Management (CPM) or DYNAMIC POWER system is actively limiting the engine's power output. This is a built-in safety feature designed to prevent severe engine damage, such as a cracked cylinder head or a seized engine, resulting from overheating. The system will remain in this derated state until the coolant temperature returns to a safe operating range.

Applies to these machines

  • Atles
  • Axion
  • Arion
  • Celtis
  • Axos
  • Lexion

Check the cause

  1. Verify coolant level in the reservoir and radiator, ensuring it is clean and meets manufacturer specifications

  2. Inspect the entire cooling system for external leaks, including hoses, radiator, water pump, and cylinder head gasket (note: EGR cooler is a known failure point for coolant loss on Arion models)

  3. Check the radiator fins and cooling package for dirt, dust, or debris obstructing airflow

  4. Inspect the engine cooling fan, verifying proper fan belt tension and correct operation of the hydraulic or viscous fan drive

  5. Examine the coolant temperature sensor and its wiring for visible damage, corrosion, or loose connections

Repair steps

  1. Address coolant issues

    Top off low coolant. If leaks are found, replace the faulty hose, gasket, or component. If coolant is contaminated, flush the entire system and refill with approved coolant.

  2. Clean the radiator

    If the radiator is clogged, carefully use compressed air or a pressure washer to clean the fins without damaging them.

  3. Repair fan system

    Replace any worn or broken fan belts. Replace the fan clutch or hydraulic motor if found to be faulty.

  4. Replace the thermostat

    If the engine is overheating but the radiator feels cool, the thermostat may be stuck closed and must be replaced.

  5. Replace coolant temperature sensor

    If the cooling system functions correctly but the fault persists, replace the coolant temperature sensor as it may be providing incorrect readings to the ECM.

  6. Perform advanced mechanical repairs

    If overheating persists after basic repairs, investigate and repair complex mechanical issues such as a failing water pump or a blown head gasket.

Parts you might need

(7)
  • Engine Coolant Temperature Sensor

    Contact authorized CLAAS dealer based on serial number. Location varies (e.g., near manifold air temp sensor and fuel temperature sensor on Celtis).

  • Coolant Temperature Sensor

    7700520269-CL

    Verify exact fitment by serial number.

  • Coolant Temperature Sensor

    679740

    Fits some Dominator, Jaguar, Lexion models.

  • Fits some Dominator, Jaguar, Lexion models.

  • Coolant Temperature Sensor

    660227.0
  • Coolant Temperature Sensor

    6575680

Get help to fix this fault by requesting a quote

Browse other CLAAS codes