768Ah

CLAAS 768Ah – Transmission control modules (TR1, TR2, TR3 / A57-1, A57-2, A57-3): Fault in Rear PTO Speed Sensor or Clutch

Issue description

This fault code indicates an issue with the signal from the rear PTO speed sensor or the associated clutch control circuit. The sensor monitors the rotational speed of the PTO shaft, which the transmission control module uses to regulate automated functions, display PTO RPM on the dashboard, and ensure safe clutch engagement and disengagement. A fault in this system can lead to the PTO being disabled as a safety measure. For instance, a related code, Id7681h, results in the PTO being turned off.

Applies to these machines

  • CLAAS Arion 640-510 series
  • CLAAS Axion 810-850 series

Check the cause

  1. Verify the fault code by noting all active codes, clearing them, and operating the tractor to see if the fault reappears

  2. Inspect connectors and wiring harness continuity between the rear PTO speed sensor and the transmission control module for open circuits, short circuits to ground, or shorts to positive voltage

  3. Check the power supply, including fuses and voltage to the control module

  4. Inspect the rear PTO speed sensor (inductive magnetic pickup) for physical damage or oil saturation

  5. Verify component compatibility, program versions, and calibrations if any parts were recently replaced

Repair steps

  1. Locate the sensor

    Find the rear PTO speed sensor mounted on the rear transmission housing, positioned over the internal PTO drive gear.

  2. Disconnect and remove

    Disconnect the electrical connector from the sensor and remove the mounting bolts securing it to the transmission housing.

  3. Install the new sensor

    Install the replacement sensor, ensuring the dual-bolt alignment flange is correctly seated to maintain the proper air-gap clearance with the internal gear.

  4. Reconnect and test

    Reconnect the electrical connector, clear the fault codes, and operate the tractor and rear PTO to ensure the fault is resolved and the dashboard RPM reading is accurate.

Parts you might need

(9)

Get help to fix this fault by requesting a quote

Browse other CLAAS codes