CLAAS Id76FDh / 76FDh – BDG (A103): No message has been transmitted by the TR3 module for at least 5 seconds.

The TR3 transmission module and its associated functions may be lost, meaning the tractor will likely enter a degraded mode or lose specific transmission capabilities.

• Axion 800
• Axion 810
• Axion 840
• Axion 850
• Axion 900
• Axion 950
• Arion 410
• Arion 430
• Arion 510
• Arion 530
• Arion 550
• Arion 620
• Arion 640
• Arion 650

1. 1

   Check the Powertrain CAN bus network: Inspect the wiring harness for continuity, open circuits, or short-circuits to ground/12V.

2. 2

   Check the TR3 transmission module (A57-3): Verify the physical condition of the module and its connectors.

3. 3

   Check the BDG CAN network communication module (A103): Ensure the gateway module is securely connected and undamaged.

4. 4

   Check Power and Ground: Verify the sources of energy (fuses, power supply, and ground connections) to both the TR3 and BDG modules.

5. 5

   Analyze Interacting Codes: Check if there are other CAN bus errors (e.g., Id7700h, Id7702h) that might indicate a broader network short rather than a failed module.

1. 1

   Document codes

   Note all error codes present on the tractor's CEBIS terminal or via the CLAAS Diagnostic System (CDS).

2. 2

   Inspect wiring

   Disconnect the harnesses linking the TR3 (A57-3) and BDG (A103) modules. Use a multimeter to test the CAN High and CAN Low lines for continuity and ensure they are not shorted to power or ground.

3. 3

   Verify power and ground

   With the key ON, verify that the TR3 module is receiving proper 12V supply and has a clean ground.

4. 4

   Replace faulty module

   If the wiring, fuses, and power/ground are all intact, the fault lies internally within either the TR3 module (failing to send) or the BDG module (failing to receive). Replace the faulty module.

5. 5

   Clear and retest

   Clear all error codes from the memory. Restart the tractor and operate it to see if the anomaly appears again. Note: Module replacement may require parameter configuration/calibration via the CLAAS Diagnostic System.