771Bh

CLAAS 771Bh – ECM: Air Pressure in the Intake

Issue description

The Engine Control Module (ECM) has detected an abnormal pressure reading in the intake manifold, indicating the pressure is too high, too low, implausible, or absent. The ECM relies on this reading to calculate the correct air-fuel mixture and to control the turbocharger. An incorrect signal can lead to poor engine performance, increased fuel consumption, higher emissions, and may cause the engine to enter a derate or limp mode to protect itself from damage.

Applies to these machines

  • Arion
  • Axos
  • Lexion
  • Tucano
  • Avero
  • Jaguar

Check the cause

  1. Visually inspect the boost pressure sensor's electrical connector for moisture, corrosion, or loose pins (CANbus connectors are particularly susceptible to moisture).

  2. Inspect the wiring harness leading to the sensor for any signs of chafing, breaks, or rodent damage.

  3. Examine the air intake system, including hoses, pipes, and the charge air cooler, for leaks, cracks, or loose connections that could cause a low pressure reading.

  4. Inspect the sensor and the intake manifold port for physical damage or soot blockage, especially on engines equipped with EGR systems.

  5. Check for a 5-volt reference signal from the ECM to the sensor's connector with the key ON and sensor disconnected.

  6. Measure the resistance on the ground circuit between the harness connector and chassis ground (should be less than 0.5 ohms).

  7. Check the signal voltage with the key ON and engine OFF (should correspond to atmospheric pressure, typically 1.5 to 2.0 volts).

  8. Monitor the signal voltage with the engine running under load (voltage should increase in response to increasing boost pressure).

  9. Use a diagnostic scan tool to read live data from the boost pressure sensor; with the key on and engine off, it should read atmospheric pressure (approximately 14.7 PSI at sea level), and compare this against a manual pressure gauge to verify accuracy.

Repair steps

  1. Resolve preliminary issues

    Repair any identified wiring issues, clean contaminated connectors, or fix leaks in the intake system. Clear the fault codes and operate the machine to see if the fault returns.

  2. Clean the sensor and port

    If the sensor and intake port are clogged with soot, remove the sensor and carefully clean both the sensor element and the port using a suitable cleaner that will not damage the sensor.

  3. Replace the sensor

    If diagnostics confirm the sensor is faulty, disconnect the electrical connector, remove the retaining bolt(s), and pull the sensor straight out. Clean the mounting surface on the manifold, install the new sensor with its O-ring, tighten bolts to manufacturer specification, and reconnect the wiring.

  4. Final verification

    Clear the fault codes from the ECM using a diagnostic tool. Start the engine, let it idle for at least one minute, and test-drive the machine under load to ensure the fault does not reappear.

Parts you might need

(4)
  • CLAAS OEM boost pressure sensor

  • Pressure Sensor

    0117211

    Listed for CLAAS Lexion and Jaguar models. Cross-reference numbers include 117211 and 0142073.

  • Intake Manifold Air Pressure Sensor / Boost Pressure Sensor

    0 281 002 743

    Bosch 4-bar sensor with integrated air temperature sensor (replaces 0 281 002 576, 0 281 006 102)

  • Intake Manifold Air Pressure Sensor

    504307953

    CNH part listed for shared engine platforms

Get help to fix this fault by requesting a quote

Browse other CLAAS codes