771Ch

CLAAS 771Ch – ENG A15: High Intake Manifold Air Pressure Voltage

Issue description

The engine control module has detected an abnormally high voltage signal from the intake manifold air pressure (boost pressure) sensor, exceeding the expected maximum threshold. When this occurs, the engine module disregards the sensor's input. While the engine may continue to operate normally, the ECM cannot accurately control the fuel-to-air mixture or turbocharger operation, which can lead to a protective reduction in engine power.

Applies to these machines

  • Arion 500 Series
  • Arion 600 Series
  • Axion Series

Check the cause

  1. Inspect the wiring harness and connectors between the intake manifold pressure sensor and the A15 engine module for damage, corrosion, loose connections, or a short circuit to a positive voltage source.

  2. Check the sensor port for blockages caused by soot or debris buildup.

  3. Examine the variable geometry turbocharger (VGT) for stuck vanes due to carbon buildup, which can cause over-boosting. Manually check the movement of the sector gear on the turbo's actuator.

  4. Inspect the air intake system for restrictions and check for exhaust leaks upstream of the turbocharger.

Repair steps

  1. Verify the fault

    Clear the fault code and operate the machine to see if the code returns before proceeding with further testing.

  2. Test the sensor

    With the ignition on and the engine off, test the sensor's voltage output. It should correspond to atmospheric pressure. Compare this value to manufacturer specifications to determine if the sensor is faulty.

  3. Clean or replace turbocharger

    If diagnostic checks indicate a VGT issue (over-boosting cause), clean the soot and carbon from the turbine housing to free up stuck vanes. Replace the turbocharger if the condition is severe.

  4. Replace the sensor

    If the sensor fails the voltage test or is otherwise determined to be faulty, replace it with the correct OEM component.

  5. Perform final system check

    Clear the fault codes and run the machine under various load conditions to ensure the repair is successful and the fault does not reappear.

Parts you might need

(4)
  • Also listed as 0011390731, 0011390730. Verify with specific machine serial number.

  • Pressure Sensor

    0142074

    Verify with specific machine serial number.

  • Pressure Sensor

    11362090

    Verify with specific machine serial number.

  • Pressure Sensor6005033102

    Verify with specific machine serial number.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes