771Eh

CLAAS 771Eh – ECU: Turbocharger Speed Excessively High

Issue description

The engine control unit (ECU) has detected that the turbocharger rotational speed exceeds the predefined maximum limit. A generic ECU fault code list specifies this condition as 'Turbocharger speed sensor (cc# 5435) speed too high - most severe level'. This is a critical fault that can lead to catastrophic turbocharger failure and potential engine damage. As a protective measure, the engine calculator reduces engine power by 20% per minute until it reaches 50% of its nominal power.

Applies to these machines

  • Axion 810-850 series
  • Lexion
  • Jaguar

Check the cause

  1. Visually inspect the turbocharger speed sensor and its wiring harness for physical damage, corrosion, loose connections, rubbing, or chafing.

  2. Use a multimeter to test the continuity and voltage of the turbocharger speed sensor's electrical connector to ensure it is within specifications.

  3. Inspect the turbocharger actuator for signs of damage or sticking (which controls the wastegate or variable vanes). Listen for unusual noises like hissing or rattling from the turbo area during acceleration.

  4. Inspect all intake plumbing for boost leaks, as this can cause the turbo to work harder and potentially overspeed.

  5. Use the CLAAS Diagnostic System (CDS) to monitor live data from the turbocharger speed sensor to determine if it is providing erratic or incorrect readings.

Repair steps

  1. Disconnect battery

    Ensure the machine is powered off and the battery is disconnected before starting any repair work.

  2. Replace turbocharger speed sensor

    If the sensor is faulty, disconnect the electrical connector, remove the retaining bolt, and carefully extract the sensor from the turbocharger housing. Install the new sensor, ensuring it is seated correctly, tighten the retaining bolt to spec, and reconnect the electrical connector.

  3. Replace turbocharger actuator

    If the actuator is faulty, disconnect the electrical connector and any linkages to the turbocharger. Remove the mounting bolts and replace the actuator. Ensure all linkages are correctly reconnected and calibrated if necessary.

  4. Clear fault codes

    Once the repair is complete, reconnect the battery and use a diagnostic tool to clear the 771Eh fault code from the ECU's memory.

  5. Test drive

    Perform a test drive, including both stop-and-go and steady-state operation, to ensure that the fault does not reappear and that the engine is performing correctly.

Parts you might need

(4)
  • Alternative part numbers: 011810.0, 1821995.0, 0000117602, 0006040150, 000676835. Unverified for this specific fault; cross-reference with machine serial number.

  • Alternative part number: 011823. Repair kits may also be available. Unverified for this specific fault; cross-reference with machine serial number.

  • Verify correct part number with a CLAAS dealer using the machine's serial number.

  • Turbocharger Speed Sensor

    B226

    Associated with the ENG (A15) engine module.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes